--- Jim Pogue <[EMAIL PROTECTED]> wrote: > > The question: When I attach the feedline at the end of the long wire, > I will > solder the coax center wire to the antenna wire. But what does one do > with > the braid or shield at the same location adjacent to the antenna > wire? > Should it be attached to anything, sealed over with black > electrician's > tape, or what? If I was putting up a dipole the answer would be easy, > but > I've never fed a long wire with coax before. > > >
Ground it at both ends if you can. For that short a length, I don't believe a matching transformer is needed unless there's a lot of radiated electrical noise around. Russ Edmunds Blue Bell, PA ( 360' ASL ) [15 mi NNW of Philadelphia] 40:08:45N; 75:16:04W, Grid FN20id <[EMAIL PROTECTED]> FM: Yamaha T-80 & Onkyo T-450RDS w/ APS9B @15' AM: Hammarlund HQ-150 & 4' FET air core loop ____________________________________________________________________________________ Yahoo! Music Unlimited Access over 1 million songs. http://music.yahoo.com/unlimited _______________________________________________ IRCA mailing list [email protected] http://montreal.kotalampi.com/mailman/listinfo/irca Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers For more information: http://www.ircaonline.org To Post a message: [email protected]
