> Colin, > > Can you tell me what the manufacturer and part number is for the case that > you used? I have a bare board and need to make a case, too. > Reply via e-mail. Here is the list reply.
Walter supplied me with a box that was too long. I cut the box length down, touched up the paint, drilled and cut and filed all the right holes - assembled and tested. Total time to do the job right: about 4+ hours. If I wasn't doing this out of pure love for the equipment this would have made very bad economic sense. The extra 100$ you spend on the "complete unit" is a drop in the button compared to my undivided attention for 4 hours. -- Colin Newell - Editor/Creator coffeecrew.com | dxer.ca Web-Design / E-Commerce / Writing Victoria, British Columbia, Canada _______________________________________________ IRCA mailing list [email protected] http://montreal.kotalampi.com/mailman/listinfo/irca Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers For more information: http://www.ircaonline.org To Post a message: [email protected]
