Here are some pictures of the phasing system. First, the vertical antenna. Took ten minutes to make. Seriously ugly...
http://www.am-dx.com/Graphics/vertical1.jpg Next, a couple of shots of the combiner as I use in the truck. This is a more elaborate version of the one shown in the schematic. This has pots for both antennas, plus a 0/180 degree switch for the loop. Since the loop pot is always at full CW, it isn't needed. The 0/180 degree switch is also not needed because simply turning the loop 180 degrees does the same thing. http://www.am-dx.com/Graphics/combiner_inside.jpg http://www.am-dx.com/Graphics/combiner_outside.jpg I'll write up a more detailed article when I get some time. Hope it's useful to y'all! Craig Healy Providence, RI _______________________________________________ IRCA mailing list IRCA@hard-core-dx.com http://montreal.kotalampi.com/mailman/listinfo/irca Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers For more information: http://www.ircaonline.org To Post a message: irca@hard-core-dx.com