To [email protected]_ (mailto:[email protected]) , Thanks for your comments. I was the original reviewer of the DT-400W in the 2008 Summertime Shootout, and have also disassembled the radio completely, to compare it with the DT-200VX it replaced. My three DT-400W review units all were ordered from Amazon.com, and all three had equally good performance. The wide-band AM sensitivity was excellent across the band, and this performance has generally been typical of the DT-400W reports from other DXers who have purchased the model. There have been at least two purchasers who were not fully satisfied with their DT-400W performance, finding it not as sensitive as other Ultralight models on either the high or low end of the AM band. Most likely, poor factory alignment is responsible for these substandard DT-400W's, and a request to Sangean for a new AM alignment might be an option, if the radio is still within the warranty period. The DT-400W's RF circuit board has been extensively redesigned from that of the DT-200VX, making it next to impossible for a hobbyist to align the 1400 kHz trimmer while the radio is operating. No doubt Sangean maintenance technicians have the two multi-pin jumpers necessary accomplish this, but a hobbyist would need to construct these jumpers out of cannibalized parts using significant time and expense, which is impractical unless the hobbyist would do these DT-400W alignments routinely. In the summer, I gave serious consideration to making these two multi-pin jumpers, but since the user reports have generally been excellent for the DT-400W, there really hasn't been enough demand for alignments to make such a project worthwhile. Poor sensitivity on the lower part of the DT-400W's AM band can be usually be easily corrected by peaking the loopstick's coil on a 600 kHz (or thereabouts) weak signal, however. For those unfamiliar with the construction of Sangean's DT series, the loopsticks are typically buried at the bottom of the radio cabinet, meaning that inverting the radio can sometimes provide a slight boost in AM sensitivity, and nulling ability. The loopstick itself is well designed, and technicians have discovered a major boost in sensitivity simply by relocating the stock loopstick outside the cabinet. Sangean buried the loopstick at the bottom of the cabinet in the DT-400W (and DT-200VX) to avoid digital RF hash at the top of the cabinet. 73, Gary DeBock In a message dated 1/17/2009 4:40:23 P.M. Pacific Standard Time, [email protected] writes:
Just got a Sangean 400W from Buy.com and am comparing it head to head with my original, old DT-200V. Sensitivity seems comparable; frankly I at first blush I can't detect the described difference wherein the 200 is more sensitive at one end of the band than the other, compared to the 400 which is more uniform across. Frankly, also, the selectivity on the 200 seems a bit tighter and it nulls slightly better. Further, the audio of the 400W seems "hissy". On further tuning around, I'm convinced this may be as much a function of the audio circuit and speaker design, as the alignment. It seems the 400W's alignment is a KHz or so off center (or the filter is not quite symmetric) as I listen 10 KHz above and below local powerhouse stations. Did I get a poorly QC'ed 400W? Would you bother trying to exchange it? How about return to Sangean? Those who have opened the case - is there a readily accessible tweak that would allow me to return it better to spec? (mailto:[email protected]?subject=) . __,_._,___ **************A Good Credit Score is 700 or Above. See yours in just 2 easy steps! (http://pr.atwola.com/promoclk/100000075x1215855013x1201028747/aol?redir=http://www.freecreditreport.com/pm/default.aspx?sc=668072%26hmpgID=62%26bcd=De cemailfooterNO62) _______________________________________________ IRCA mailing list [email protected] http://montreal.kotalampi.com/mailman/listinfo/irca Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers For more information: http://www.ircaonline.org To Post a message: [email protected]
