What might have worked better is to remove the single
center conductor and replace it with a twisted pair of
#24 or so wires.
In this case you used two feedlines, one for each side
of the balanced output.
Ah. These days a pair of RG-6 cables would be about the same. Maybe
covering them with braid shield or even aluminum foil would be equivalent.
Even better than RG-6 is 75 ohm video cable. The center conductor for RG-6
is copper coated steel. Video cable is just copper. Less loss at MW
frequencies.
Craig Healy
Providence, RI
_______________________________________________
IRCA mailing list
[email protected]
http://montreal.kotalampi.com/mailman/listinfo/irca
Opinions expressed in messages on this mailing list are those of the original
contributors and do not necessarily reflect the opinion of the IRCA, its
editors, publishing staff, or officers
For more information: http://www.ircaonline.org
To Post a message: [email protected]
