The entire AM band is 1710-520, so 1.2 mHz. If you add LW, it's 1710-190 = 1.520, so you're covered either way.
Russ Edmunds 15 mi NNW of Philadelphia Grid FN20id <[email protected]> -------------------------------------------- On Tue, 2/25/14, Les Rayburn <[email protected]> wrote: Subject: Re: [IRCA] SDR-Console and the Perseus SDR Volume Levels To: "Mailing list for the International Radio Club of America" <[email protected]> Date: Tuesday, February 25, 2014, 2:30 PM Don, I was advised that if you lowered the sampling rate to 950, the Perseus could record 1750 KHz worth of bandwidth (the entire AM band). Have you tried that? I assume quality might suffer a bit, but that might be offset by the ability to record the entire band. Les Rayburn, Director High Noon Film 130 1st Avenue West Alabaster, AL 35007-8536 (205) 621-7500 (205) 621-7505 FAX (205) 253-4867 CELL http://www.highnoonfilm.com --------------------------------------------- This e-mail contains information that may be confidential or privileged and is intended only for the person(s) named above. Any other distribution, copying or disclosure is strictly prohibited. If you have received this e-mail in error, please notify the sender immediately and return the original transmission to the above address by mail without making a copy. On 2/25/2014 1:02 PM, Don Moman VE6JY wrote: > There is a volume tab in the SDR Console next to the speaker icon in the > VFO pane. Even tho it says 75 the actual level may be anything - it is just > an icon. > > Using the native Perseus software recording is 1600 khz maximum - it > records what you have the screen width set to. > > 73 Don > VE6JY > > > On Tue, Feb 25, 2014 at 5:49 PM, Les Rayburn <[email protected]> wrote: > >> Got the new Perseus SDR hooked up and running last night using SDRV4.1 >> downloaded from the Perseus web site. No problems at all with the initial >> installation on Windows 7 Pro. Had it working within moments. >> >> One issue I did notice was that when I used the Perseus with the >> SDR-Console software, the AF output volume was much lower compared to the >> native Perseus software. No idea why this would be, and couldn't find a >> place to adjust the level inside the SDR-Console software. Can someone >> offer assistance? >> >> RF levels appeared to be the same for both software. >> >> So far, I love the Perseus! One other question--how much bandwidth can the >> Perseus record in I/O mode? I've seen some sites that say it's limited to >> 800 KHz, others say 1600 KHz, and others 2 MHz. My understanding is that it >> would cover the entire AM band, which would be 1710 KHz (1.7 MHz) >> >> >> -- >> 73, >> >> >> Les Rayburn, N1LF >> Maylene, AL >> EM63 >> >> Member NRC, IRCA, & Medium Wave DX Circle >> Former CPC Chairman for NRC/IRCA >> >> SDR-IQ,Funcube Pro, Wellbrooke ALA-1530+ loop, LF Engineering Active Whips, >> Quantum Phaser, Kiwa Loop, Palstar MW Pre-Selector >> >> _______________________________________________ >> IRCA mailing list >> [email protected] >> http://montreal.kotalampi.com/mailman/listinfo/irca >> >> Opinions expressed in messages on this mailing list are those of the >> original contributors and do not necessarily reflect the opinion of the >> IRCA, its editors, publishing staff, or officers >> >> For more information: http://www.ircaonline.org >> >> To Post a message: [email protected] >> >> > _______________________________________________ > IRCA mailing list > [email protected] > http://montreal.kotalampi.com/mailman/listinfo/irca > > Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers > > For more information: http://www.ircaonline.org > > To Post a message: [email protected] > > -- 73, Les Rayburn, N1LF Maylene, AL EM63 Member NRC, IRCA, & Medium Wave DX Circle Former CPC Chairman for NRC/IRCA SDR-IQ,Funcube Pro, Wellbrooke ALA-1530+ loop, LF Engineering Active Whips, Quantum Phaser, Kiwa Loop, Palstar MW Pre-Selector _______________________________________________ IRCA mailing list [email protected] http://montreal.kotalampi.com/mailman/listinfo/irca Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers For more information: http://www.ircaonline.org To Post a message: [email protected] _______________________________________________ IRCA mailing list [email protected] http://montreal.kotalampi.com/mailman/listinfo/irca Opinions expressed in messages on this mailing list are those of the original contributors and do not necessarily reflect the opinion of the IRCA, its editors, publishing staff, or officers For more information: http://www.ircaonline.org To Post a message: [email protected]
