Gary - 
 
We split up with the idea of comparing the 2 locations. We think 4 has horizon 
blockage from 300 degrees northward so might not give us some Asians. It does 
have a better "backscreen" cliff wall behind it.
 
Rockworks 2 has no horizon blockage towards Asia. But a bit more signal might 
leak in from behind with the less imposing cliff wall behind it.
 
Guy and I have a better impression of Asiatic reception from Rockworks  4 than 
you. Perhaps because we have been there in the fall (TP season) while your 
comments mention July lack of TPs.
 
Chuck
 
> Date: Sat, 24 Oct 2015 20:00:08 -0700
> From: [email protected]
> To: [email protected]
> Subject: Re: [IRCA] Rockworks, Oregon Non-DX Report for Oct. 24th
> 
> Hi Gary, there were two of us at Rock works 2 and two of us at Rockworks 4.
> In fact, each location had a Flag or ALA100LN mast supported loop (50 or
> more feet in circumference) as well as one or more Wellbrook 1-meter active
> loops at each site.
> 
> Our results were the same at each turnout, no matter what antenna :^(
> 
> It's safe to say that it just wasn't a morning to set the log books on fire!
> 
> 73,
> 
> Guy Atkins
> Puyallup, WA
> DXing at the Rockworks cliffs near Manzanita, OR
> _______________________________________________
> IRCA mailing list
> [email protected]
> http://montreal.kotalampi.com/mailman/listinfo/irca
> 
> Opinions expressed in messages on this mailing list are those of the original 
> contributors and do not necessarily reflect the opinion of the IRCA, its 
> editors, publishing staff, or officers
> 
> For more information: http://www.ircaonline.org
> 
> To Post a message: [email protected]
> 
                                          
_______________________________________________
IRCA mailing list
[email protected]
http://montreal.kotalampi.com/mailman/listinfo/irca

Opinions expressed in messages on this mailing list are those of the original 
contributors and do not necessarily reflect the opinion of the IRCA, its 
editors, publishing staff, or officers

For more information: http://www.ircaonline.org

To Post a message: [email protected]

Reply via email to