TO UNSUBSCRIBE: email "unsubscribe issforum" in the body of your message to
[EMAIL PROTECTED]  Contact [EMAIL PROTECTED] for help with any problems!
----------------------------------------------------------------------------

First, you should ask CheckPoint to see what they say, but as far as I can
remember when I was testing this (way back when I wrote the doc) you did NOT
need the VPN license version of CheckPoint.  The next question, who did you
purchase this copy of RealSecure from?  Was it CheckPoint or someone else,
and if it was someone else, did they get it from CheckPoint?

There are two different versions of RealSecure.  The regular one, and one
that we call "Cprism".  Cprism uses a different license key scheme than the
regular RealSecure.  Regular RealSecure uses an ISS license to enable the
product.  The "Cprism" version, sold by CheckPoint, uses the ISS License to
basically tell the software "use teh CheckPoint license".  At this point you
have to use your CheckPoint FW-1 License to enable RealSecure.  THis version
offers CheckPoint exclusive enhancements, which will eventually be available
to all of our customers (at least that is my understanding).  This "Cprism"
version is supported by CheckPoint, and because of the differing license
scheme it may be possible that CheckPoint requires teh purchase of their VPN
software FW-1, but I am not positive.

LIke I said, I would check w/ whoever you bought it from, and with
CheckPoint to make sure.

Alex F

-----Original Message-----
From: Walker Andrew [mailto:[EMAIL PROTECTED]]
Sent: Thursday, April 06, 2000 12:26 PM
To: '[EMAIL PROTECTED]'
Subject: Real Secure: OPSEC interface to Checkpoint FW 1: What version
of FW1 is required ?



TO UNSUBSCRIBE: email "unsubscribe issforum" in the body of your message to
[EMAIL PROTECTED]  Contact [EMAIL PROTECTED] for help with any
problems!
----------------------------------------------------------------------------

The OPSEC interface allows a response to a certain network event to a
checkpoint FW1.  You use the putkey process for public key exchange between
the FW1 management console and the RS engine.  Then you configure your
policy from the RS management console to make a RS engine instruct your FW
to take a specific response to the detected network event.

At least I believe the above is a correct summary of the process.

Anyway, I couldn't make it work.  After a long time I heard that I need a
Checkpoint license for FW 1 that includes the VPN option to make the RS
OPSEC interface work.

Is this correct ??

Need fairly urgent explanation.

Thanks to all.

Andrew Walker



Mailto:[EMAIL PROTECTED]

************************************************************************
The information in this email is confidential and is intended solely 
for the addressee(s).                                   
Access to this email by anyone else is unauthorised. If you are not 
an intended recipient, you must not read, use or disseminate the 
information contained in the email.                     
Any views expressed in this message are those of the individual sender,
except where the sender specifically states them to be the views of 
The Capital Markets Company.                              

http://www.capco.com
***********************************************************************



Reply via email to