Hello! I'm trying to apply X-Press updates to a network sensor. It doesn't work at all. I tried it with right-klick on the sensor itself and the group... No success. I received the following two messages:
Applying update to group: "An upgrade of type 'X-Press Update' was currently not available for sensor [EMAIL PROTECTED]". Applying update to sensor: "No updates currently available for this component". Well, I remember that there is a hint during the basic installation (deployment manager) of the siteprotector. in the "Siteprotector Installation and Configuration Guide Version 2.0, Service Pack 3" on page 44 I found the following: 12. Type your name and email address, and then click Next. Note: This information is optional, although you will not be able to download X-Press Updates if you do not enter it on this page. See the SiteProtector Help for information about X-Press Updates. The installation program may last as long as 20 minutes, depending on the speed of your computer and the available RAM. When the installation is complete, a summary box appears indicating the success of the installation. I didn't enter any information there during the installation... Now my question: is it possible to configure this information afterwards? Or do I have to install the whole stuff again just to enter this info? :-o Is there another procedure to manually place the *.ini and *.xpu files in the correct directory of the management console? Thanx for any feedback! Elloit -- +++ NEU bei GMX und erstmalig in Deutschland: T�V-gepr�fter Virenschutz +++ 100% Virenerkennung nach Wildlist. Infos: http://www.gmx.net/virenschutz _______________________________________________ ISSForum mailing list [EMAIL PROTECTED] TO UNSUBSCRIBE OR CHANGE YOUR SUBSCRIPTION, go to https://atla-mm1.iss.net/mailman/listinfo/issforum To contact the ISSForum Moderator, send email to [EMAIL PROTECTED] The ISSForum mailing list is hosted and managed by Internet Security Systems, 6303 Barfield Road, Atlanta, Georgia, USA 30328.
