Dear all, Recently i have installed a ISS SiteProtector and i have problem in applying a customised response. I created a new network response using the derive new button and after configuring the new response when i try to apply the response to a sensor, i get a message saying that the response is successfully applied and the status of the sensor goes to stop mode and then when i try to start the sensor i get a failed message and the error message i get is "Sensor failed to initialize and exited. Please check the event log on the sensor machine" but i don't see any error message in sensor machine. Please let me know what is the solution for this problem. I am able to successfully apply the built-in network response to the sensor without any errors.
Regards, G G Venkat Raman "Excellence is not a destination; it is a continuous journey that never ends." _______________________________________________ ISSForum mailing list [email protected] TO UNSUBSCRIBE OR CHANGE YOUR SUBSCRIPTION, go to https://atla-mm1.iss.net/mailman/listinfo/issforum To contact the ISSForum Moderator, send email to [EMAIL PROTECTED] The ISSForum mailing list is hosted and managed by Internet Security Systems, 6303 Barfield Road, Atlanta, Georgia, USA 30328.
