[
https://issues.apache.org/jira/browse/HBASE-7709?page=com.atlassian.jira.plugin.system.issuetabpanels:comment-tabpanel&focusedCommentId=13728432#comment-13728432
]
Lars Hofhansl commented on HBASE-7709:
--------------------------------------
In fact we will have the following setup:
A <-> B, C <-> D, E <-> F, ... (where these are all pairs of DR clusters. We
keep them both as master so that a failover for other reasons, even just as
exercise does not need further configuration).
We sometime migrate an entire cluster, say A. In that case we'd also replicate
A -> C. Currently we can't do that, because the data from A would bounce
between C and D forever.
> Infinite loop possible in Master/Master replication
> ---------------------------------------------------
>
> Key: HBASE-7709
> URL: https://issues.apache.org/jira/browse/HBASE-7709
> Project: HBase
> Issue Type: Bug
> Components: Replication
> Affects Versions: 0.94.6, 0.95.1
> Reporter: Lars Hofhansl
> Fix For: 0.98.0, 0.95.2, 0.94.11
>
>
> We just discovered the following scenario:
> # Cluster A and B are setup in master/master replication
> # By accident we had Cluster C replicate to Cluster A.
> Now all edit originating from C will be bouncing between A and B. Forever!
> The reason is that when the edit come in from C the cluster ID is already set
> and won't be reset.
> We have a couple of options here:
> # Optionally only support master/master (not cycles of more than two
> clusters). In that case we can always reset the cluster ID in the
> ReplicationSource. That means that now cycles > 2 will have the data cycle
> forever. This is the only option that requires no changes in the HLog format.
> # Instead of a single cluster id per edit maintain a (unordered) set of
> cluster id that have seen this edit. Then in ReplicationSource we drop any
> edit that the sink has seen already. The is the cleanest approach, but it
> might need a lot of data stored per edit if there are many clusters involved.
> # Maintain a configurable counter of the maximum cycle side we want to
> support. Could default to 10 (even maybe even just). Store a hop-count in the
> WAL and the ReplicationSource increases that hop-count on each hop. If we're
> over the max, just drop the edit.
--
This message is automatically generated by JIRA.
If you think it was sent incorrectly, please contact your JIRA administrators
For more information on JIRA, see: http://www.atlassian.com/software/jira
