On Tuesday 11 October 2005 22:27, Hans Verkuil wrote:
> On Tuesday 11 October 2005 22:10, Christoph Schulz wrote:
> > Hello,
> >
> > with ivtv 0.4.0 I have no radio anymore (noise on all frequencies). With
> > ivtv 0.3.8 I got radio with the kernel supplied tuner & tda9887 module
> > (kernel 2.6.12-gentoo-r9). With ivtv 0.4.0, I have no radio regardless
> > whether I use the ivtv or kernel modules. TV recording is OK (video +
> > sound), and I noticed no differences between the four possibilities
> > (0.3.8 kernel/ivtv modules, 0.4.0 kernel/ivtv modules).
> >
> > I'm not using any module options, but I tried "tda9887=0", which was
> > needed with earlier ivtv versions. But, as I expected, there was no
> > difference.
> >
> > By the way, the only difference with the exception of the new driver
> > version to the old (running) system is the encoder firmware: The new
> > gentoo package now uses the recommended 0x02050032 version; before that,
> > I always used the older 0x02040011 version. Do you think this can make a
> > difference wrt. radio recording? I'm afraid I haven't yet got the time
> > to check it out, but I'll surely do so (if nobody objects to it).
>
> You're not the only one. It isn't working anymore for me either :-(
> It's once again something to do with the tda9887. My sole PVR card without
> that chip works fine for radio.
>
> I'm looking into it.
Sigh. That's the umphteenth time I forget that I also have to specify the
correct /dev/video2X output. I'm going to add additional checks in ivtv-radio
to check if the radio device and the PCM output device belong to the same
card.
In other words, radio works fine for me.
Hans
_______________________________________________
ivtv-devel mailing list
[email protected]
http://ivtvdriver.org/mailman/listinfo/ivtv-devel
