I am still having the buzzing channel problem. Whenever something bright hits the screen it bleeds into the audio channel. This started when I upgraded to 4.0 (which appears to have permanently broke my cards ability to auto detect audio mode. Even when downgrading as far as 2.0 line. I have it set manually to mode 0x020 that I scavenged from an earlier log. Without it half the channels have no sound. ) the buzzing still exists with the earlier driver versions also.
I upgraded to the new recommended firmware, it still won't autodetect audio mode. I am still checking for buzzing. It APPEARS to be better at the moment, but all the local origination programming (when it appears the worse) has gone off the air for the night. I have also attached the card directly to the outside cable line with same buzzing (and autodetect) problem. Also, is it normal to be able to pull 17vac off the shielding of a disconnected main tv cable? I get about 6v off the pin. Reason I checked it is because it was giving me a nice tingle handling the raw wire. I forgot to check the potential from pin to shielding. By main TV cable I mean the cable they run from the junction box not the pole. I removed all splitters and other devices from wire is what I mean. This driver has come a long way in a short time and I highly appreciate your work. I just wish I could find a way to help the project more. Thanks for your help. Brent PS. There has been a lot of changes recently with the structure of the driver's distribution and compile methods and I have been out of the loop for quite a while. Can someone forward me to a page that can sort of give me a "conversion manual" for the driver install process? thanks _______________________________________________ ivtv-devel mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-devel
