On Jan 11, 2006, at 10:15 PM, Dave Germiquet wrote: I am getting the following with Ivtv 0.4 any help would heb appreciated.
With a PVR-150 (WINTV
[mpeg2video @ 0x2aaaabdc0230]ac-tex damaged at 18 11
[mpeg2video @ 0x2aaaabdc0230]end mismatch left=148
[mpeg2video @ 0x2aaaabdc0230]end mismatch left=580
[mpeg2video @ 0x2aaaabdc0230]end mismatch left=289
2006-01-11 23:08:03.060 GetNextFreeFrame() served a busy frame 6. Dropping. uUUuUUUUUUUUUuuUUUULUUuUUUUUUUU
[mpeg2video @ 0x2aaaabdc0230]ac-tex damaged at 8 25
[mpeg2video @ 0x2aaaabdc0230]ac-tex damaged at 27 29
[mpeg2video @ 0x2aaaabdc0230]invalid cbp at 28 29
[mpeg2video @ 0x2aaaabdc0230]end mismatch left=142
[mpeg2video @ 0x2aaaabdc0230]ac-tex damaged at 21 19
[mpeg2video @ 0x2aaaabdc0230]ac-tex damaged at 27 29
[mpeg2video @ 0x2aaaabdc0230]end mismatch left=290
[mpeg2video @ 0x2aaaabdc0230]ac-tex damaged at 29 29
[mpeg2video @ 0x2aaaabdc0230]end mismatch left=45
[mpeg2video @ 0x2aaaabdc0230]ac-tex damaged at 27 29
That looks like a bad mpeg. Does this happen on all channels / shows, or just a single one? What kind of logs do you get during the actual recording (the above is from playback)? Check both Myth and dmesg.
Keith C
The below looks alright at first pass. Device:
05:03.0 Multimedia video controller: Internext Compression Inc iTVC16 (CX23416) MPEG-2 Encoder (rev 01)
Dmesg output
ivtv: ==================== START INIT IVTV ====================
ivtv: version 0.4.1 (tagged release) loading
ivtv: Linux version: 2.6.14.3-default gcc-4.0
--
ivtv: In case of problems please include the debug info between
ivtv: the START INIT IVTV and END INIT IVTV lines, along with
ivtv: any module options, when mailing the ivtv-users mailinglist.
ieee1394: Initialized config rom entry `ip1394'
ohci_hcd 0000:00:02.0: wakeup
intel8x0_measure_ac97_clock: measured 56803 usecs
intel8x0: clocking to 47009
eth0: forcedeth.c: subsystem: 01043:816a bound to 0000:00:0a.0
ivtv0: Autodetected WinTV PVR 150 card (cx23416 based)
ACPI: PCI Interrupt Link [APC1] enabled at IRQ 16
ACPI: PCI Interrupt 0000:05:03.0[A] -> Link [APC1] -> GSI 16 (level, low) -> IRQ
58
ivtv0: Unreasonably low latency timer, setting to 64 (was 32)
i2c-algo-bit.o: (0) scl=1, sda=1
i2c-algo-bit.o: (1) scl=1, sda=0
i2c-algo-bit.o: (2) scl=1, sda=1
i2c-algo-bit.o: (3) scl=0, sda=1
i2c-algo-bit.o: (4) scl=1, sda=1
i2c-algo-bit.o: ivtv i2c driver #0 passed test.
ohci1394: $Rev: 1313 $ Ben Collins <[EMAIL PROTECTED]>
ACPI: PCI Interrupt Link [APC4] enabled at IRQ 19
ACPI: PCI Interrupt 0000:05:02.0[A] -> Link [APC4] -> GSI 19 (level, low) -> IRQ
66
PCI: Via IRQ fixup for 0000:05:02.0, from 5 to 2
ohci1394: fw-host0: OHCI-1394 1.0 (PCI): IRQ=[66] MMIO=[c6000000-c60007ff] Max
Packet=[2048]
tveeprom: ivtv version
tveeprom: Hauppauge: model = 26032, rev = C182, serial# = 2963068
tveeprom: tuner = LG TAPC H791F (idx = 82, type = 39)
tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000)
tveeprom: audio processor = CX25841 (type = 23)
tveeprom: decoder processor = CX25841 (type = 1c)
ivtv0: i2c attach to card #0 ok [client=tveeprom, addr=50]
tuner (ivtv): chip found at addr 0xc2 i2c-bus ivtv i2c driver #0
ivtv0: i2c attach to card #0 ok [client=(tuner unset), addr=61]
usb 1-4: new low speed USB device using ohci_hcd and address 2
cx25840 2-0044: ivtv driver
cx25840 2-0044: cx25841-23 found @ 0x88 (ivtv i2c driver #0)
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
cdrom: open failed.
ieee1394: Host added: ID:BUS[0-00:1023] GUID[0011d800002c26d9]
usbcore: registered new driver hiddev
input.c: calling hotplug without a hotplug agent defined
input: USB HID v1.11 Mouse [Logitech USB RECEIVER] on usb-0000:00:02.0-4
usbcore: registered new driver usbhid
drivers/usb/input/hid-core.c: v2.6:USB HID core driver
cx25840 2-0044: loaded v4l-cx25840.fw firmware (14264 bytes)
ivtv0: i2c attach to card #0 ok [client=cx25840, addr=44]
Adding 1012084k swap on /dev/hda2. Priority:-1 extents:1 across:1012084k
wm8775 2-001b: ivtv driver
wm8775 2-001b: chip found @ 0x36 (ivtv i2c driver #0)
ivtv0: i2c attach to card #0 ok [client=wm8775, addr=1b]
bootsplash: status on console 0 changed to on
ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes)
ivtv0: Encoder revision: 0x02050032
ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total)
ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total)
ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total)
ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total)
tuner: type set to 39 (LG NTSC (newer TAPC series)) by ivtv i2c driver #0
BIOS EDD facility v0.16 2004-Jun-25, 2 devices found
ivtv0: Initialized WinTV PVR 150, card #0
ivtv: ==================== END INIT IVTV ====================
_______________________________________________ ivtv-devel mailing list
|
_______________________________________________
ivtv-devel mailing list
[email protected]
http://ivtvdriver.org/mailman/listinfo/ivtv-devel
