I have your exact same setup, same card, same kernel, same distro. I didn't use apt to install ivtv, but rather I compiled 0.4.3 from source.
Compile it: sudo -i wget http://dl.ivtvdriver.org/ivtv/archive/0.4.x/ivtv-0.4.3.tar.gz tar -xzvf ivtv-0.4.3.tar.gz cd ivtv-0.4.3 make sudo make install Install the firmware: cd utils wget ftp://ftp.shspvr.com/download/wintv-pvr_150-500/inf/pvr_2.0.24.23035.zip wget ftp://ftp.shspvr.com/download/wintv-pvr_250-350/inf/pvr_1.18.21.22254_inf.zip unzip pvr_2.0.24.23035.zip ./ivtvfwextract.pl pvr_1.18.21.22254_inf.zip cp HcwMakoA.ROM /usr/lib/hotplug/firmware/v4l-cx25840.fw cp HcwFalcn.rom /usr/lib/hotplug/firmware/v4l-cx2341x-enc.fw mv /lib/modules/ivtv-fw-dec.bin /usr/lib/hotplug/firmware/ mv /lib/modules/ivtv-fw-enc.bin /usr/lib/hotplug/firmware/ cp ../v4l-cx2341x-init.mpg /usr/lib/hotplug/firmware ln -s /usr/lib/hotplug/firmware/ivtv-fw-dec.bin /usr/lib/hotplug/firmware/v4l-cx2341x-dec.fw Make sure this is in your /etc/modprobe.d/aliases file: alias char-major-81-0 ivtv Finish up: depmod modprobe ivtv dmesg Look for errors in the dmesg output (post everything new that comes up back to the mailing list if it still doesn't work.) Test it: mplayer /dev/video0 Good luck. Vic On Saturday 18 March 2006 12:14 pm, Christopher M. Jones wrote: > I apologize if this issue is off-topic for this list. However, the user > list seems pretty low volume, and I haven't had any response from my > original post. Here is that original post: I'm having trouble with my > pvr-150 mce card. The problem is that I can't get capture working at all, > though I seem to be able to tune the card, set channels, etc. And ivtvctl > seems to detect a signal, which > disappears when I disconnect the input cable. So I know something is > working, but it is not getting through. > > I'm running Ubuntu Dapper Drake: > [EMAIL PROTECTED]:~# uname -a > Linux copernicus 2.6.15-18-386 #1 PREEMPT Thu Mar 9 14:41:49 UTC 2006 > i686 GNU/Linux > IVTV version 0.4-0.4.3 apt-gotten from > deb http://www.hellion.org.uk/debian sid main > deb-src http://www.hellion.org.uk/debian sid main > > I've read the warnings to make sure the device is properly tuned and the > input device set. I've tried all the inputs, 0-4, thus: > [EMAIL PROTECTED]:~# ivtvctl -p 0 > ioctl VIDIOC_S_INPUT ok > Video input set to 0 > > I tune it: > [EMAIL PROTECTED]:~# ivtv-tune -c34 > /dev/video0: 283.250 MHz (Signal Detected) > > cat /dev/video0 > capture.mpg results in an empty file, for each input. > > I did notice the following in dmesg, after stopping the capture: > [4295302.343000] ivtv0 warning: ENC: REG_DMAXFER 2 wait failed > [4295304.371000] ivtv0 warning: ENC: DMA still Pending while stopping > capture! > [4295305.353000] ivtv0 warning: DEC: REG_ENCSG1LEN wait failed > > I wonder if this is related to buggy dma on my board? I've seen the > warnings that the VIA chipset is buggy and has some problems with > ivtv... > > dmesg output: > > [4294702.273000] Linux video capture interface: v1.00 > [4294702.378000] ivtv: ==================== START INIT IVTV > ==================== > [4294702.378000] ivtv: version 0.4.3 (tagged release) loading > [4294702.378000] ivtv: Linux version: 2.6.15-17-386 preempt 486 gcc-4.0 > [4294702.378000] ivtv: In case of problems please include the debug > info between > [4294702.378000] ivtv: the START INIT IVTV and END INIT IVTV lines, > along with > [4294702.378000] ivtv: any module options, when mailing the ivtv-users > mailinglist. > [4294702.378000] ivtv0: Autodetected WinTV PVR 150 card (cx23416 based) > [4294702.378000] ACPI: PCI Interrupt 0000:00:0c.0[A] -> Link [LNKA] -> > GSI 10 (level, low) -> IRQ 10 > [4294702.379000] ivtv0: Unreasonably low latency timer, setting to 64 > (was 32) > [4294702.444000] tveeprom: ivtv version > [4294702.444000] tveeprom: Hauppauge: model = 26552, rev = B258, serial# > = 7499341 > [4294702.444000] tveeprom: tuner = Philips FM1236 MK3 (idx = 58, type = > 43) > [4294702.444000] tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = > 0x00001000) > [4294702.444000] tveeprom: audio processor = CX25843 (type = 25) > [4294702.444000] tveeprom: decoder processor = CX25843 (type = 1e) > [4294702.444000] ivtv0: i2c attach to card #0 ok [client=tveeprom, > addr=50] > [4294702.471000] tuner (ivtv): chip found at addr 0xc2 i2c-bus ivtv i2c > driver #0 > [4294702.471000] ivtv0: i2c attach to card #0 ok [client=(tuner unset), > addr=61] > [4294702.673000] cx25840 1-0044: cx25843-23 found @ 0x88 (ivtv i2c > driver #0) > [4294703.527000] ACPI: PCI Interrupt 0000:00:08.0[A] -> Link [LNKA] -> > GSI 10 (level, low) -> IRQ 10 > [4294703.582000] ieee1394: Host added: ID:BUS[0-00:1023] > GUID[0005160000451322] > [4294703.827000] input: ImPS/2 Generic Wheel Mouse > as /class/input/input1 > [4294703.877000] ts: Compaq touchscreen protocol output > [4294706.658000] cx25840 1-0044: loaded v4l-cx25840.fw firmware (14264 > bytes) > [4294706.706000] ivtv0: i2c attach to card #0 ok [client=cx25840, > addr=44] > [4294706.781000] wm8775 1-001b: chip found @ 0x36 (ivtv i2c driver #0) > [4294706.788000] ivtv0: i2c attach to card #0 ok [client=wm8775, > addr=1b] > [4294706.835000] tda9887 1-0043: (ivtv) chip found @ 0x86 (ivtv i2c > driver #0) > [4294706.835000] ivtv0: i2c attach to card #0 ok [client=tda9887, > addr=43] > [4294707.640000] ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 > bytes) > [4294707.850000] ivtv0: Encoder revision: 0x02050032 > [4294707.850000] ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 > buffers (4096KB total) > [4294707.851000] ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 > buffers (2048KB total) > [4294707.852000] ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 > buffers (2048KB total) > [4294707.853000] ivtv0: Allocate DMA encoder PCM audio stream: 455 x > 4608 buffers (2048KB total) > [4294707.855000] ivtv0: Create encoder radio stream > [4294707.855000] tuner: type set to 43 (Philips NTSC MK3 (FM1236MK3 or > FM1236/F)) by ivtv i2c driver #0 > [4294708.042000] ivtv0: Initialized WinTV PVR 150, card #0 > [4294708.047000] ivtv: ==================== END INIT IVTV > ==================== > > output of ivtvctl -a > > [EMAIL PROTECTED]:~# ivtv -a > bash: ivtv: command not found > [EMAIL PROTECTED]:~# ivtvctl -a > ioctl IVTV_IOC_G_CODEC ok > Codec parameters > aspect : 2 > audio : 0x00e9 > bframes : 3 > bitrate_mode: 0 > bitrate : 8000000 > bitrate_peak: 9600000 > dnr_mode : 0 > dnr_spatial : 0 > dnr_temporal: 8 > dnr_type : 0 > framerate : 0 > framespergop: 15 > gop_closure : 1 > pulldown : 0 > stream_type : 14 > ioctl VIDIOC_G_FMT ok > Type : Video Capture > Width : 720 > Height : 480 > ioctl VIDIOC_QUERYCAP ok > Driver name : ivtv > Card type : WinTV PVR 150 > Bus info : 0000:00:0c.0 > Driver version: 1027 > Capabilities : 0x01070011 > ioctl: VIDIOC_ENUMINPUT > Input : 0 > Name : Tuner > Type : 0x00000001 > Audioset: 0x00000003 > Tuner : 0x00000000 > Standard: 0x0000000000003000 ( NTSC ) > Status : 0 > > Input : 1 > Name : Composite 0 > Type : 0x00000002 > Audioset: 0x00000003 > Tuner : 0x00000000 > Standard: 0x00000000007F7FFF ( PAL NTSC SECAM ) > Status : 0 > > Input : 2 > Name : Composite 1 > Type : 0x00000002 > Audioset: 0x00000003 > Tuner : 0x00000000 > Standard: 0x00000000007F7FFF ( PAL NTSC SECAM ) > Status : 0 > > Input : 3 > Name : S-Video 0 > Type : 0x00000002 > Audioset: 0x00000003 > Tuner : 0x00000000 > Standard: 0x00000000007F7FFF ( PAL NTSC SECAM ) > Status : 0 > > Input : 4 > Name : S-Video 1 > Type : 0x00000002 > Audioset: 0x00000003 > Tuner : 0x00000000 > Standard: 0x00000000007F7FFF ( PAL NTSC SECAM ) > Status : 0 > ioctl VIDIOC_G_INPUT ok > Video input = 4 > ioctl: VIDIOC_ENUMOUTPUT > ioctl VIDIOC_G_OUTPUT failed: Invalid argument > ioctl: VIDIOC_ENUMAUDIO > Input : 0 > Name : Tuner Audio In > > Input : 1 > Name : Audio Line 1 > > Input : 2 > Name : Audio Line 2 > > Input : 3 > Name : Audio Line 3 > > Input : 4 > Name : Audio Line 4 > ioctl VIDIOC_G_AUDIO ok > Audio input = 2: Audio Line 2 > ioctl VIDIOC_G_FREQUENCY ok > Frequency = 3476 > ioctl: VIDIOC_ENUMSTD > index : 0 > ID : 0x0000000000003000 > Name : NTSC > Frame period: 1001/30000 > Frame lines : 525 > > index : 1 > ID : 0x00000000000000FF > Name : PAL > Frame period: 1/25 > Frame lines : 625 > > index : 2 > ID : 0x00000000007F0000 > Name : SECAM > Frame period: 1/25 > Frame lines : 625 > ioctl VIDIOC_G_STD ok > Video standard = 0x00003000 > ioctl: VIDIOC_QUERYCTRL > Brightness = 128 > Contrast = 64 > Saturation = 64 > Hue = 0 > Volume = 60928 > Mute = 0 > > > > _______________________________________________ > ivtv-devel mailing list > [email protected] > http://ivtvdriver.org/mailman/listinfo/ivtv-devel -- Vic Fryzel (vic at shellsage dot com) http://shellsage.com/ Key id C7B780CA = 3235 2261 807B 451C DA4D DFBA CAA7 80CF C7B7 80CA
pgp0B7TAi6l8P.pgp
Description: PGP signature
_______________________________________________ ivtv-devel mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-devel
