Hi

I have tryed ivtv driver but I think that it dont init
properly.

Did someone have this laptop, and have it working?

Best regards
   Milan

ivtv:  ==================== START INIT IVTV
====================
ivtv:  version 0.7.0 (tagged release) loading
ivtv:  Linux version: 2.6.17-1.2174_FC5 mod_unload 686
REGPARM 4KSTACKS gcc-4.1
ivtv:  In case of problems please include the debug info
between
ivtv:  the START INIT IVTV and END INIT IVTV lines, along
with
ivtv:  any module options, when mailing the ivtv-users
mailinglist.
ivtv0: Unknown card: vendor/device: 4444/0016
ivtv0:               subsystem vendor/device: 1461/c136
ivtv0:               cx23416 based
ivtv0: Defaulting to Hauppauge WinTV PVR-150 card
ivtv0: Please mail the vendor/device and subsystem
vendor/device IDs and what kind of
ivtv0: card you have to the ivtv-devel mailinglist
(www.ivtvdriver.org)
ivtv0: Prefix your subject line with [UNKNOWN CARD].
ACPI: PCI Interrupt 0000:01:02.0[A] -> GSI 23 (level, low)
-> IRQ 185
tveeprom 0-0050: Huh, no eeprom present (err=-121)?
tveeprom 0-0050: Encountered bad packet header [00].
Corrupt or not a Hauppauge eeprom.
ivtv0: No tuner detected, default to NTSC
tuner 0-0061: chip found @ 0xc2 (ivtv i2c driver #0)
cx25840 0-0044: cx25843-23 found @ 0x88 (ivtv i2c driver
#0)
cx25840 0-0044: loaded v4l-cx25840.fw firmware (16382
bytes)
ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes)
ivtv0: Encoder revision: 0x02050032
ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768
buffers (4096KB total)
ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers
(2048KB total)
ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers
(2048KB total)
ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608
buffers (2048KB total)
tuner 0-0061: type set to 0 (Temic PAL (4002 FH5))
ivtv0: i2c hardware 0x00000020 not found for command
0x4008646d!
tuner 0-0061: i2c i/o error: rc == -121 (should be 4)
tuner 0-0061: i2c i/o error: rc == -121 (should be 4)
ivtv0: Initialized Hauppauge WinTV PVR-150, card #0
ivtv:  ====================  END INIT IVTV
 ====================



01:02.0 Multimedia video controller: Internext Compression
Inc iTVC16 (CX23416) MPEG-2 Encoder (rev 01)
        Subsystem: Avermedia Technologies Inc Unknown
device c136
        Control: I/O- Mem+ BusMaster- SpecCycle- MemWINV+
VGASnoop- ParErr- Stepping- SERR- FastB2B-
        Status: Cap+ 66MHz- UDF- FastB2B- ParErr-
DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
        Interrupt: pin A routed to IRQ 185
        Region 0: Memory at b8000000 (32-bit, prefetchable)
[size=64M]
        Capabilities: [44] Power Management version 2
                Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA
PME(D0-,D1-,D2-,D3hot-,D3cold-)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-


_______________________________________________
ivtv-devel mailing list
[email protected]
http://ivtvdriver.org/mailman/listinfo/ivtv-devel

Reply via email to