Sander Sweers wrote: > Hans Verkuil wrote: >> I would appreciate it if a few people could give it a spin for some >> preliminary feedback. Don't forget to read the README! Esp. the >> required osd_compat=1 module option for those who use ivtv_fb with >> MythTV. The trunk driver will work for both 2.6.18 and 2.6.19 kernels. > > I get a lot of the below with mythtv (0.20 + fixes) which does not > happen with 0.9 svn. Also mplayer is struggling but no messages. > > ivtv1: All encoder MPEG stream buffers are full. Dropping data. > ivtv1: Cause: the application is not reading fast enough.
I forget to add it also gives corruption on the screen with the occasional pop. Greets Sander > ivtv: ==================== START INIT IVTV ==================== > ivtv: version 0.10.0 (development revision 3735) loading > ivtv: Linux version: 2.6.19-gentoo-r2 mod_unload > ivtv: In case of problems please include the debug info between > ivtv: the START INIT IVTV and END INIT IVTV lines, along with > ivtv: any module options, when mailing the ivtv-users mailinglist. > ivtv0: Autodetected Hauppauge card (cx23416 based) > ACPI: PCI Interrupt 0000:00:09.0[A] -> GSI 16 (level, low) -> IRQ 16 > ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) > ivtv0: Encoder revision: 0x02050032 > tuner 0-0043: chip found @ 0x86 (ivtv i2c driver #0) > tda9887 0-0043: tda988[5/6/7] found @ 0x43 (tuner) > tuner 0-0061: chip found @ 0xc2 (ivtv i2c driver #0) > cx25840 0-0044: cx25842-23 found @ 0x88 (ivtv i2c driver #0) > cx25840 0-0044: loaded v4l-cx25840.fw firmware (16382 bytes) > wm8775 0-001b: chip found @ 0x36 (ivtv i2c driver #0) > tveeprom 0-0050: The eeprom says no radio is present, but the tuner type > tveeprom 0-0050: indicates otherwise. I will assume that radio is present. > tveeprom 0-0050: Hauppauge model 26039, rev F0A5, serial# 8837856 > tveeprom 0-0050: tuner model is TCL MPE05-2 (idx 105, type 38) > tveeprom 0-0050: TV standards PAL(B/G) PAL(I) SECAM(L/L') PAL(D/D1/K) > (eeprom 0x74) > tveeprom 0-0050: audio processor is CX25842 (idx 36) > tveeprom 0-0050: decoder processor is CX25842 (idx 29) > tveeprom 0-0050: has radio, has IR remote > ivtv0: Autodetected Hauppauge WinTV PVR-150 > ivtv0: reopen i2c bus for IR-blaster support > tuner 0-0043: chip found @ 0x86 (ivtv i2c driver #0) > tda9887 0-0043: tda988[5/6/7] found @ 0x43 (tuner) > tuner 0-0061: chip found @ 0xc2 (ivtv i2c driver #0) > cx25840 0-0044: cx25842-23 found @ 0x88 (ivtv i2c driver #0) > cx25840 0-0044: loaded v4l-cx25840.fw firmware (16382 bytes) > wm8775 0-001b: chip found @ 0x36 (ivtv i2c driver #0) > ivtv0: Registered device video0 for encoder MPEG (4 MB) > ivtv0: Registered device video32 for encoder YUV (2 MB) > ivtv0: Registered device vbi0 for encoder VBI (1 MB) > ivtv0: Registered device video24 for encoder PCM audio (1 MB) > ivtv0: Registered device radio0 for encoder radio > tuner 0-0061: type set to 38 (Philips PAL/SECAM multi (FM1216ME MK3)) > ivtv0: Initialized Hauppauge WinTV PVR-150, card #0 > ivtv: ====================== NEXT CARD ====================== > ivtv1: Autodetected Hauppauge card (cx23416 based) > ACPI: PCI Interrupt 0000:00:0c.0[A] -> GSI 17 (level, low) -> IRQ 17 > ivtv1: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) > ivtv1: Encoder revision: 0x02050032 > tuner 1-0043: chip found @ 0x86 (ivtv i2c driver #1) > tda9887 1-0043: tda988[5/6/7] found @ 0x43 (tuner) > tuner 1-0061: chip found @ 0xc2 (ivtv i2c driver #1) > cx25840 1-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #1) > cx25840 1-0044: loaded v4l-cx25840.fw firmware (16382 bytes) > wm8775 1-001b: chip found @ 0x36 (ivtv i2c driver #1) > tveeprom 1-0050: Hauppauge model 26559, rev G189, serial# 9512947 > tveeprom 1-0050: tuner model is TCL MFPE05 2 (idx 89, type 38) > tveeprom 1-0050: TV standards PAL(B/G) PAL(I) SECAM(L/L') PAL(D/D1/K) > (eeprom 0x74) > tveeprom 1-0050: audio processor is CX25843 (idx 37) > tveeprom 1-0050: decoder processor is CX25843 (idx 30) > tveeprom 1-0050: has radio, has no IR remote > ivtv1: Autodetected Hauppauge WinTV PVR-150 > ivtv1: Registered device video1 for encoder MPEG (4 MB) > ivtv1: Registered device video33 for encoder YUV (2 MB) > ivtv1: Registered device vbi1 for encoder VBI (1 MB) > ivtv1: Registered device video25 for encoder PCM audio (1 MB) > ivtv1: Registered device radio1 for encoder radio > tuner 1-0061: type set to 38 (Philips PAL/SECAM multi (FM1216ME MK3)) > ivtv1: Initialized Hauppauge WinTV PVR-150, card #1 > ivtv: ==================== END INIT IVTV ==================== > _______________________________________________ ivtv-devel mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-devel
