I think that I got this wrong.......
I copied and executed
./get_dvb_firmware.pl cx18 (I probably should not have done this?)
./get_dvb_firmware.pl mpc718
and ended up with the following files
v4l-cx23418-dig.fw
v4l-cx23418-apu.fw
dvb-cx18-mpc718-mt352.fw
v4l-cx23418-cpu.fw
Yuan MPC718 TV Tuner Card 2.13.10.1016.zip
I copied dvb-cx18-mpc718-mt352.fw to /lib/firmware
---------------------------------------------------------------------
I then unzipped Yuan....zip
and ended up with these files
drvInstall.ini h mpc718_32bit mpc718_64bit setall.txt setup.exe Usage.txt
in the unzip-created sub directory.
---------------------------------------------------------------------------------------------
I then followed the instructions in Usage.txt which stated that I run
./DPInst_Setup.exe 1000 1 /s
this is where I started to get a bit confused.
I assume that this meant the "DPINnst.exe" in sub-dir mpc718_32bit not the Setup.exe in the current directory .....?
(I didn't find a DPInst_Setup.exe)
This would not run, I got the following error message and could not proceed further
run-detectors: unable to find an interpreter for ./DPInst_Setup.exe
Was this what you expected me to run? Your instructions stated
2. Compile, install, and test the updated cx18 driver from that repo.
Which I expected to find in the zip archive. As I said I got somewhat confused at this stage.
P.S : I've sent my full dmesg to you under seperate cover.
Steve
_______________________________________________ ivtv-devel mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-devel
