I assume you're trying the right input? The init looks fine to me.
On Sun, 30 Jan 2005 21:51:08 -0700, Dan Bartels <[EMAIL PROTECTED]> wrote: > > > > I'm getting nothing but static on my PVR-250. I think that it started when > I switched to the 2.6.10-1.737_FC3 kernel, but I'm not entirely sure (Didn't > watch TV or check it for a while in there.) But it used to work fine, > before all that. Changing channels (either through Myth TV or ptune-gui.pl) > doesn't seem to do anything. I have searched enough of the list to know > about the "alias tveeprom tveeprom-ivtv," and while that did help the tuner > detection issue (I had that as well) it changed nothing with the static on > every channel. (Through the RCA jack, the card works fine, it works > completely under windows XP) > > > > I have a PVR-250 with the conexant cx23416-12 chip. > > The tuner module has a sticker that says NTSC/NTSC-J 32032 Rev B182. � 2002 > Hauppage computer works. > > > > I am currently using the "ivtv-0.3.2c-66.rhfc3.at" rpm from atrpms, but I > have tried the 0.2 and the ck100zz versions as well, with no luck. > > > > ---/etc/modprobe.conf > > # ivtv modules setup > > alias char-major-61 lirc_i2c > > alias char-major-81 videodev > > alias char-major-81-0 ivtv > > alias tveeprom tveeprom-ivtv > > > > --- dmesg > > ivtv: ==================== START INIT IVTV ==================== > > ivtv: version 0.3.2 (c) loading > > ivtv: Linux version: 2.6.10-1.741_FC3 686 REGPARM 4KSTACKS gcc-3.4 > > ivtv: In case of problems please include the debug info > > ivtv: between the START INIT IVTV and END INIT IVTV lines when > > ivtv: mailing the ivtv-devel mailinglist. > > ivtv: Autodetected WinTV PVR 250 card > > ivtv: Found an iTVC16 based chip > > ACPI: PCI interrupt 0000:00:09.0[A] -> GSI 10 (level, low) -> IRQ 10 > > ivtv: Unreasonably low latency timer, setting to 64 (was 32) > > ivtv: VIA PCI device: 0x0305 vendor: 0x1106 > > lirc_i2c: chip found @ 0x18 (Hauppauge IR) > > ivtv: i2c attach [client=Hauppauge IR,ok] > > lirc_dev: lirc_register_plugin:sample_rate: 10 > > tveeprom: Hauppauge: model = 32032, rev = B182, serial# = 2832436 > > tveeprom: tuner = LG TAPC H791F (idx = 82, type = 39) > > tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000) > > tveeprom: audio_processor = MSP3440 (type = 11) > > ivtv: i2c attach [client=tveeprom[0],ok] > > ivtv: Tuner Type 39, Tuner formats 0x00001000, Radio: yes, Model 0x00891612, > Revision 0x00000000 > > ivtv: NTSC tuner detected > > ivtv: Radio detected > > tuner: chip found at addr 0xc2 i2c-bus ivtv i2c driver #0 > > ivtv: i2c attach [client=(tuner unset),ok] > > saa7115: starting probe for adapter SMBus Via Pro adapter at 5000 (0x0) > > saa7115: starting probe for adapter ivtv i2c driver #0 (0x10005) > > saa7115: detecting saa7115 client on address 0x42 > > saa7115: writing init values > > ivtv: i2c attach [client=saa7115[0],ok] > > saa7115: status: (1E) 0x48, (1F) 0xc0 > > msp34xx: init: chip=MSP3448W-B3 +nicam +simple +simpler +radio mode=simple > > ivtv: i2c attach [client=MSP3448W-B3,ok] > > msp3410: daemon started > > ivtv: Encoder revision: 0x02040011 > > ivtv: Configuring WinTV PVR 250 card with 5 streams > > ivtv: Create DMA stream 0 using 256 16384 byte buffers 4194304 kbytes total > > ivtv: Registered v4l2 device, streamtype 0 minor 0 > > ivtv: Create DMA stream 1 > > ivtv: Registered v4l2 device, streamtype 1 minor 32 > > ivtv: Create stream 2 using 40 52224 byte buffers 2097152 kbytes total > > ivtv: Registered v4l2 device, streamtype 2 minor 224 > > ivtv: Create DMA stream 3 using 455 4608 byte buffers 2097152 kbytes total > > ivtv: Registered v4l2 device, streamtype 3 minor 24 > > ivtv: Create stream 4 > > ivtv: Registered v4l2 device, streamtype 4 minor 64 > > ivtv: Setting Tuner 39 > > tuner: type set to 39 (LG NTSC (newer TAPC series)) by ivtv i2c driver #0 > > saa7115: decoder set input (4) > > saa7115: now setting Composite input > > ivtv: Setting audio matrix to input 3, output 1 > > ivtv: Switching standard to NTSC. > > saa7115: decoder set norm NTSC > > saa7115: set audio: 0x01 > > ivtv: Initialized WinTV PVR 250, card #0 > > ivtv: ==================== END INIT IVTV ==================== > > > > Thanks in advance, > > --Dan ------------------------------------------------------- This SF.Net email is sponsored by: IntelliVIEW -- Interactive Reporting Tool for open source databases. Create drag-&-drop reports. Save time by over 75%! Publish reports on the web. Export to DOC, XLS, RTF, etc. Download a FREE copy at http://www.intelliview.com/go/osdn_nl _______________________________________________ ivtv-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/ivtv-devel
