ivtv: no version for "struct_module" found: kernel tainted. ivtv: ==================== START INIT IVTV ==================== ivtv: version 0.2.0 (rc3b) loading ivtv: Linux version: 2.6.10-1.9_FC2 686 REGPARM 4KSTACKS gcc-3.3 ivtv: In case of problems please include the debug info ivtv: between the START INIT IVTV and END INIT IVTV lines when ivtv: mailing the ivtv-devel mailinglist. ivtv: Unknown card: vendor/device: 4444/0016, subsystem vendor/device: 0070/0009 ivtv: Defaulting to WinTV PVR 250 card ivtv: Please mail the vendor/device and subsystem vendor/device IDs and what kind of ivtv: card you have to the ivtv-devel mailinglist: http://sourceforge.net/projects/ivtv ivtv: Prefix your subject line with [UNKNOWN CARD]. ivtv: Found an iTVC16 based chip ACPI: PCI Interrupt Link [LNKC] enabled at IRQ 5 PCI: setting IRQ 5 as level-triggered ACPI: PCI interrupt 0000:02:04.0[A] -> GSI 5 (level, low) -> IRQ 5 ivtv: Unreasonably low latency timer, setting to 64 (was 32) ivtv: XXX PCI device: 0x1130 vendor: 0x8086 tveeprom: Hauppauge: model = 32032, rev = B382, serial# = 7261703 tveeprom: tuner = LG TAPC H791F (idx = 82, type = 39) tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000) tveeprom: audio_processor = MSP3440 (type = 11) ivtv: i2c attach [client=tveeprom[0],ok] ivtv: Tuner Type 39, Tuner formats 0x00001000, Radio: yes, Model 0x00893612, Revision 0x00000000 ivtv: NTSC tuner detected ivtv: Radio detected tuner: chip found at addr 0xc2 i2c-bus ivtv i2c driver #0 ivtv: i2c attach [client=(tuner unset),ok] saa7115: starting probe for adapter ivtv i2c driver #0 (0x10005) saa7115: detecting saa7115 client on address 0x42 saa7115: writing init values ivtv: i2c attach [client=saa7115[0],ok] saa7115: status: (1E) 0x01, (1F) 0xc0 msp34xx: ivtv version msp34xx: init: chip=MSP3448W-B3, has NICAM support, simple (D) mode, simpler (G) no-thread mode msp34xx: $Id$ compiled on: Jan 23 2005 03:21:47 ivtv: i2c attach [client=MSP3448W-B3,ok] ivtv: Encoder revision: 0x02040024 ivtv: Encoder Firmware is buggy, use version 0x02040011 ivtv: Configuring WinTV PVR 250 card with 5 streams ivtv: Create DMA stream 0 using 256 16384 byte buffers 4194304 kbytes total ivtv: Registered v4l2 device, streamtype 0 minor 0 ivtv: Create DMA stream 1 ivtv: Registered v4l2 device, streamtype 1 minor 32 ivtv: Create stream 2 using 40 52224 byte buffers 2097152 kbytes total eth0: no IPv6 routers present ivtv: Registered v4l2 device, streamtype 2 minor 224 ivtv: Create DMA stream 3 using 455 4608 byte buffers 2097152 kbytes total ivtv: Registered v4l2 device, streamtype 3 minor 24 ivtv: Create stream 4 ivtv: Registered v4l2 device, streamtype 4 minor 64 ivtv: Setting Tuner 39 tuner: type set to 39 (LG NTSC (newer TAPC series)) by ivtv i2c driver #0 ivtv: Setting audio matrix to input 3, output 1 ivtv: Switching standard to NTSC. ivtv: ivtv_enc_thread: pid = 2681, itv = 0xe0aa91a0 saa7115: decoder set norm NTSC saa7115: set audio: 0x01 ivtv: Initialized WinTV PVR 250, card #0 ivtv: ==================== END INIT IVTV ====================
This is a PVR-250 capture card. ------------------------------------------------------- This SF.Net email is sponsored by: IntelliVIEW -- Interactive Reporting Tool for open source databases. Create drag-&-drop reports. Save time by over 75%! Publish reports on the web. Export to DOC, XLS, RTF, etc. Download a FREE copy at http://www.intelliview.com/go/osdn_nl _______________________________________________ ivtv-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/ivtv-devel
