Oh, it's not loading the firmware, that's the error it's giving. Thanks, Chris On Tue, May 24, 2005 at 10:03:48AM -0400, Hilary L Hertzoff wrote: > On Tuesday 24 May 2005 09:20, Chris Kennedy wrote: > > I think the firmware isn't under /lib/modules/ > > > > Thanks, > > Chris > > Where should it go then? That is where the files are currently (and on the > old system). > > Hilary > > > > > On Tue, May 24, 2005 at 09:07:26AM -0400, Hilary L Hertzoff wrote: > > > I've been running IVTV on SuSE 9.2 for about 6-8 months. > > > > > > Now on a new install of 9.3 on a new harddrive, I'm running into > > > problems. None of the other hardware has changed. > > > > > > I've tried using the included IVTV package, reinstalling the package, > > > upgrading to the latest tarball, reinstalling the firmware, copying over > > > my modprobe files from the old installation, replacing the firmware files > > > with newly extracted ones and with the ones from the old installation. > > > > > > None of this has fixed the problem. When I run modprobe IVTV I get the > > > following messages. Everything seems to be fine, but it's not finding > > > the firmware (which is in the same place as it was in the old install). > > > > > > Any thoughts? > > > > > > Thanks > > > Hilary > > > > > > May 24 09:05:59 linux kernel: ivtv: ==================== START INIT IVTV > > > ==================== > > > May 24 09:05:59 linux kernel: ivtv: version 0.3.2 (c) loading > > > May 24 09:05:59 linux kernel: ivtv: Linux version: 2.6.11.4-20a-default > > > gcc-3.3 > > > May 24 09:05:59 linux kernel: ivtv: In case of problems please include > > > the debug info > > > May 24 09:05:59 linux kernel: ivtv: between the START INIT IVTV and END > > > INIT IVTV lines when > > > May 24 09:05:59 linux kernel: ivtv: mailing the ivtv-devel mailinglist. > > > May 24 09:05:59 linux kernel: ivtv: Autodetected WinTV PVR 250 card > > > May 24 09:05:59 linux kernel: ivtv: Found an iTVC16 based chip > > > May 24 09:05:59 linux kernel: ACPI: PCI interrupt 0000:00:08.0[A] -> GSI > > > 19 (level, low) -> IRQ 185 > > > May 24 09:05:59 linux kernel: ivtv: VIA PCI device: 0x3188 vendor: 0x1106 > > > May 24 09:05:59 linux kernel: i2c-algo-bit.o: (0) scl=1, sda=1 > > > May 24 09:05:59 linux kernel: i2c-algo-bit.o: (1) scl=1, sda=0 > > > May 24 09:05:59 linux kernel: i2c-algo-bit.o: (2) scl=1, sda=1 > > > May 24 09:05:59 linux kernel: i2c-algo-bit.o: (3) scl=0, sda=1 > > > May 24 09:05:59 linux kernel: i2c-algo-bit.o: (4) scl=1, sda=1 > > > May 24 09:05:59 linux kernel: i2c-algo-bit.o: ivtv i2c driver #0 passed > > > test. May 24 09:05:59 linux kernel: ivtv: i2c attach [client=tveeprom,ok] > > > May 24 09:05:59 linux kernel: tuner: chip found at addr 0xc2 i2c-bus ivtv > > > i2c driver #0 > > > May 24 09:05:59 linux kernel: ivtv: i2c attach [client=(tuner unset),ok] > > > May 24 09:05:59 linux kernel: saa7115: starting probe for adapter ivtv > > > i2c driver #0 (0x10005) > > > May 24 09:05:59 linux kernel: saa7115: detecting saa7115 client on > > > address 0x42 > > > May 24 09:05:59 linux kernel: saa7115: writing init values > > > May 24 09:05:59 linux kernel: ivtv: i2c attach [client=saa7115[6],ok] > > > May 24 09:05:59 linux kernel: saa7115: status: (1E) 0x48, (1F) 0xc0 > > > May 24 09:05:59 linux kernel: msp34xx: init: chip=MSP3445G-B8 +nicam > > > +simple +simpler +radio mode=simple > > > May 24 09:05:59 linux kernel: ivtv: i2c attach [client=MSP3445G-B8,ok] > > > May 24 09:05:59 linux kernel: msp3410: daemon started > > > May 24 09:05:59 linux kernel: tveeprom: Hauppauge: model = 32062, rev = > > > B185, serial# = 7363116 > > > May 24 09:05:59 linux kernel: tveeprom: tuner = TCL 2002N 6A (idx = 85, > > > type = 50) > > > May 24 09:05:59 linux kernel: tveeprom: tuner fmt = NTSC(M) (eeprom = > > > 0x08, v4l2 = 0x00001000) > > > May 24 09:05:59 linux kernel: tveeprom: audio_processor = MSP3445 (type = > > > 12) May 24 09:05:59 linux kernel: ivtv: Tuner Type 50, Tuner formats > > > 0x00001000, Radio: yes, Model 0x00891615, Revision 0x80344736 > > > May 24 09:05:59 linux kernel: ivtv: NTSC tuner detected > > > May 24 09:05:59 linux kernel: ivtv: Radio detected > > > May 24 09:05:59 linux udevd[2303]: move seq 1129 with timeout 10 to exec > > > queue May 24 09:05:59 linux kernel: ivtv: requesting firmware > > > May 24 09:06:00 linux udevd[2303]: move seq 1130 with timeout 10 to exec > > > queue May 24 09:06:00 linux kernel: ivtv: firmware load failed > > > May 24 09:06:00 linux kernel: ivtv: failed loading encoder firmware > > > May 24 09:06:00 linux kernel: ivtv: Error loading firmware -3! > > > May 24 09:06:00 linux kernel: ivtv: Error -3 initializing firmware. > > > May 24 09:06:00 linux kernel: ivtv: Error -12 on initialization > > > May 24 09:06:00 linux kernel: ivtv-iTVC15_16_mpg2_encoder_card: probe of > > > 0000:00:08.0 failed with error -12 > > > May 24 09:06:00 linux kernel: ivtv: ==================== END INIT IVTV > > > ================ > > > > > > > > > ------------------------------------------------------- > > > This SF.Net email is sponsored by Oracle Space Sweepstakes > > > Want to be the first software developer in space? > > > Enter now for the Oracle Space Sweepstakes! > > > http://ads.osdn.com/?ad_id=7412&alloc_id=16344&op=click > > > _______________________________________________ > > > ivtv-devel mailing list > > > [email protected] > > > https://lists.sourceforge.net/lists/listinfo/ivtv-devel > > > ------------------------------------------------------- > This SF.Net email is sponsored by Yahoo. > Introducing Yahoo! Search Developer Network - Create apps using Yahoo! > Search APIs Find out how you can build Yahoo! directly into your own > Applications - visit http://developer.yahoo.net/?fr=offad-ysdn-ostg-q22005 > _______________________________________________ > ivtv-devel mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/ivtv-devel
-- --- Chris Kennedy / [EMAIL PROTECTED] Engineer KMOS-TV/KTBG-FM Broadcasting Services Department Central Missouri State University ------------------------------------------------------- This SF.Net email is sponsored by Yahoo. Introducing Yahoo! Search Developer Network - Create apps using Yahoo! Search APIs Find out how you can build Yahoo! directly into your own Applications - visit http://developer.yahoo.net/?fr=offad-ysdn-ostg-q22005 _______________________________________________ ivtv-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/ivtv-devel
