Nick Rosier wrote: >On 10/22/05, dave sailer <[EMAIL PROTECTED]> wrote: > > >>I've had a setup working with a pvr250 for some time now. I added a >>pvr150 card and can't get the tuner set correctly. >> >>lspci -v >> >>0000:01:08.0 Multimedia video controller: Internext Compression Inc >>iTVC16 (CX23416) MPEG-2 Encoder (rev 01) >> Subsystem: Hauppauge computer works Inc.: Unknown device 8003 >> Flags: bus master, medium devsel, latency 64, IRQ 18 >> Memory at e0000000 (32-bit, prefetchable) >> Capabilities: [44] Power Management version 2 >> >>0000:01:0a.0 Multimedia video controller: Internext Compression Inc >>iTVC16 (CX23416) MPEG-2 Encoder (rev 01) >> Subsystem: Hauppauge computer works Inc.: Unknown device 4801 >> Flags: bus master, medium devsel, latency 64, IRQ 16 >> Memory at e4000000 (32-bit, prefetchable) >> Capabilities: [44] Power Management version 2 >> >> >> >> >> >> >>dmesg >>ivtv: ==================== START INIT IVTV ==================== >>ivtv: version 0.4.0 (tagged release) loading >>ivtv: Linux version: 2.6.11-gentoo-r9 SMP preempt K7 gcc-3.3 >>ivtv: In case of problems please include the debug info >>ivtv: between the START INIT IVTV and END INIT IVTV lines when >>ivtv: mailing the ivtv-devel mailinglist. >>ivtv0: Autodetected WinTV PVR 150 card (iTVC16 based) >>ACPI: PCI interrupt 0000:01:08.0[A] -> GSI 18 (level, high) -> IRQ 18 >>ivtv0: Unreasonably low latency timer, setting to 64 (was 32) >>ivtv0: i2c attach to card #0 ok [client=tveeprom, addr=50] >>tveeprom: Hauppauge: model = 26032, rev = C199, serial# = 8181626 >>tveeprom: tuner = <unknown> (idx = 99, type = -1068812320) >>tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000) >>tveeprom: audio_processor = TDA9850 (type = 3) >>tuner: chip found at addr 0xc2 i2c-bus ivtv i2c driver #0 >>ivtv0: i2c attach to card #0 ok [client=(tuner unset), addr=61] >>cx25840 3-0044: cx25841-23 found @ 0x88 (ivtv i2c driver #0) >>cx25840 3-0044: loaded /lib/modules/HcwMakoA.ROM firmware (14264 bytes) >>ivtv0: i2c attach to card #0 ok [client=cx25840, addr=44] >>wm8775 3-001b: chip found @ 0x36 (ivtv i2c driver #0) >>ivtv0: i2c attach to card #0 ok [client=wm8775, addr=1b] >>ivtv0: loading /lib/modules/ivtv-fw-enc.bin >>ivtv0: Encoder revision: 0x02050032 >>ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) >>ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total) >>ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total) >>ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB >>total) >>ivtv0: Create encoder radio stream >>tuner: tuner type not set >>ivtv0: Initialized WinTV PVR 150, card #0 >>ivtv: ====================== NEXT CARD ====================== >>ivtv1: Autodetected WinTV PVR 250 card (iTVC16 based) >>ACPI: PCI Interrupt Link [APC1] enabled at IRQ 16 >>ACPI: PCI interrupt 0000:01:0a.0[A] -> GSI 16 (level, high) -> IRQ 16 >>ivtv1: Unreasonably low latency timer, setting to 64 (was 32) >>ivtv1: i2c attach to card #1 ok [client=tveeprom, addr=50] >>tuner: chip found at addr 0xc2 i2c-bus ivtv i2c driver #1 >>ivtv1: i2c attach to card #1 ok [client=(tuner unset), addr=61] >>tda9885/6/7: chip found @ 0x86 >>ivtv1: i2c attach to card #1 ok [client=tda9887, addr=43] >>tveeprom: Hauppauge: model = 32552, rev = C168, serial# = 7245920 >>tveeprom: tuner = LG TAPE H001F MK3 (idx = 68, type = 47) >>tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000) >>tveeprom: audio_processor = MSP3440 (type = 11) >>saa7115 4-0021: saa7115 found @ 0x42 (ivtv i2c driver #1) >>ivtv1: i2c attach to card #1 ok [client=saa7115, addr=21] >>msp34xx: init: chip=MSP3448W-B3 +nicam +simple +simpler +radio mode=simple >>msp3410: daemon started >>ivtv1: i2c attach to card #1 ok [client=MSP3448W-B3, addr=40] >>ivtv1: loading /lib/modules/ivtv-fw-enc.bin >>ivtv1: Encoder revision: 0x02050032 >>ivtv1: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) >>ivtv1: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total) >>ivtv1: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total) >>ivtv1: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB >>total) >>ivtv1: Create encoder radio stream >>tuner: type set to 47 (LG NTSC (TAPE series)) by ivtv i2c driver #1 >>ivtv1: Initialized WinTV PVR 250, card #1 >>ivtv: ==================== END INIT IVTV ==================== >> >> >> >>the new card is now the first card detected and dmeg shows that the >>tuner is not detected. >> >>I'm using gentoo portage for the ivtv install, which seems to be pretty >>good these days. ivtv verison is ivtv-0.4.0-r2. This installs the >>firmware and the checksums match th recommended versions. I had a heck >>of a time with the same issue with the original card, but I don't >>remember much about how I solved it. I seem to remember it was a >>combination of things that are now pretty solid in the kernel, ivtv >>drivers and gentoo package. >> >> > >You seem to be using the kernel tveeprom in stead of the ivtv-version. >Check /lib/modules/<kernel>/driver/media/video and make sure there's >no tveeprom.ko and tuner.ko there (rename or remove them). > >N. > >_______________________________________________ >ivtv-users mailing list >[email protected] >http://ivtvdriver.org/mailman/listinfo/ivtv-users > > > that was it. thanks! been too long since I did this and forgot about that stuff. Apparently the kernel versions work with the old card cuz It's been that way for awhile! Need to add that to my list of stuff to do when I recompile the kernel.
_______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
