I just discovered that my new PVR-500 doesn't tune channel 7. I haven't tested every channel (surfing is *so* darned slow in mythtv) but many other channels *are* working: 2, 6, 8, 58, 63, 66 and more. The PVR-350 tunes channel 7 without problem. This is a US cable system (Astound.)
What's the status of the 'missing channels' posts I saw in the past couple of weeks? My ivtv boot messages are below. Thanks, Kirk ivtv: ==================== START INIT IVTV ==================== ivtv: version 0.4.3 (development snapshot compiled on Wed 25 Jan 2006 08:36:25 PM PST) loading ivtv: Linux version: 2.6.14.6-up-wcpvr01 gcc-3.4 ivtv: In case of problems please include the debug info between ivtv: the START INIT IVTV and END INIT IVTV lines, along with ivtv: any module options, when mailing the ivtv-users mailinglist. ivtv0: Autodetected WinTV PVR 350 card (cx23415 based) ACPI: PCI Interrupt 0000:01:02.0[A] -> GSI 17 (level, low) -> IRQ 185 ivtv0: Unreasonably low latency timer, setting to 64 (was 32) tveeprom: The eeprom says no radio is present, but the tuner type 68 tveeprom: indicates otherwise. I will assume that radio is present. tveeprom: ivtv version tveeprom: Hauppauge: model = 48132, rev = K268, serial# = 2985761 tveeprom: tuner = LG TAPE H001F MK3 (idx = 68, type = 47) tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000) tveeprom: audio processor = MSP4448 (type = 1b) tveeprom: decoder processor = SAA7115 (type = 13) ivtv0: i2c attach to card #0 ok [client=tveeprom, addr=50] tuner (ivtv): chip found at addr 0xc2 i2c-bus ivtv i2c driver #0 ivtv0: i2c attach to card #0 ok [client=(tuner unset), addr=61] saa7115 0-0021: ivtv driver saa7115 0-0021: saa7115 found @ 0x42 (ivtv i2c driver #0) ivtv0: i2c attach to card #0 ok [client=saa7115, addr=21] saa7127 0-0044: ivtv driver saa7127 0-0044: saa7129 found @ 0x88 (ivtv i2c driver #0) ivtv0: i2c attach to card #0 ok [client=saa7127, addr=44] msp3400 0-0040: ivtv driver msp3400 0-0040: chip=MSP4448G-A2 +nicam +simple +simpler +radio mode=simpler ivtv0: i2c attach to card #0 ok [client=MSP4448G-A2, addr=40] msp3400 0-0040: msp34xxg daemon started tda9887 0-0043: (ivtv) chip found @ 0x86 (ivtv i2c driver #0) ivtv0: i2c attach to card #0 ok [client=tda9887, addr=43] ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) ivtv0: loaded v4l-cx2341x-dec.fw firmware (262144 bytes) ivtv0: Encoder revision: 0x02050032 ivtv0: Decoder revision: 0x02020023 ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total) ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total) ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total) ivtv0: Create encoder radio stream ivtv0: Allocate DMA decoder MPEG stream: 16 x 65536 buffers (1024KB total) ivtv0: Allocate DMA decoder VBI stream: 512 x 2048 buffers (1024KB total) ivtv0: Create decoder VOUT stream ivtv0: Allocate DMA decoder YUV stream: 24 x 43200 buffers (1024KB total) ivtv0: loaded v4l-cx2341x-init.mpg firmware (155648 bytes) tuner: type set to 47 (LG NTSC (TAPE series)) by ivtv i2c driver #0 tuner: switching to v4l2 tuner: tv freq set to 67.25 tuner: tv 0x07 0x10 0x8e 0x01 ivtv0: Initialized WinTV PVR 350, card #0 ivtv: ====================== NEXT CARD ====================== ivtv1: Autodetected WinTV PVR 150 card (cx23416 based) ACPI: PCI Interrupt 0000:02:08.0[A] -> GSI 22 (level, low) -> IRQ 193 ivtv1: Unreasonably low latency timer, setting to 64 (was 32) tveeprom: Second (radio) tuner idx 101 tveeprom: ivtv version tveeprom: Hauppauge: model = 23552, rev = D487, serial# = 8921592 tveeprom: tuner = Samsung TCPN 2121P30A (idx = 87, type = 68) tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000) tveeprom: audio processor = CX25843 (type = 25) tveeprom: decoder processor = CX25843 (type = 1e) ivtv1: i2c attach to card #1 ok [client=tveeprom, addr=50] tuner (ivtv): chip found at addr 0xc0 i2c-bus ivtv i2c driver #1 TEA5767 detected. ivtv1: i2c attach to card #1 ok [client=(tuner unset), addr=60] tuner: type set to 62 (Philips TEA5767HN FM Radio) by autodetect type set to 62 (Philips TEA5767HN FM Radio) tuner (ivtv): chip found at addr 0xc2 i2c-bus ivtv i2c driver #1 ivtv1: i2c attach to card #1 ok [client=(tuner unset), addr=61] ivtv1: This is the first unit of a PVR500 cx25840 1-0044: ivtv driver cx25840 1-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #1) cx25840 1-0044: loaded v4l-cx25840.fw firmware (14264 bytes) ivtv1: i2c attach to card #1 ok [client=cx25840, addr=44] wm8775 1-001b: ivtv driver wm8775 1-001b: chip found @ 0x36 (ivtv i2c driver #1) ivtv1: i2c attach to card #1 ok [client=wm8775, addr=1b] ivtv1: Detected a TEA5767 radio tuner. Enabling radio support. ivtv1: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) ivtv1: Encoder revision: 0x02050032 ivtv1: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) ivtv1: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total) ivtv1: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total) ivtv1: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total) ivtv1: Create encoder radio stream tuner: type set to 68 (Samsung TCPN 2121P30A) by ivtv i2c driver #1 tuner: switching to v4l2 tuner: tv freq set to 67.25 tuner: tv 0x07 0x10 0xce 0x01 ivtv1: Initialized WinTV PVR 500 (unit #1), card #1 ivtv: ====================== NEXT CARD ====================== ivtv2: Autodetected WinTV PVR 150 card (cx23416 based) ACPI: PCI Interrupt 0000:02:09.0[A] -> GSI 21 (level, low) -> IRQ 201 ivtv2: Unreasonably low latency timer, setting to 64 (was 32) tveeprom: Second (radio) tuner idx 101 tveeprom: ivtv version tveeprom: Hauppauge: model = 23552, rev = D487, serial# = 8921592 tveeprom: tuner = Samsung TCPN 2121P30A (idx = 87, type = 68) tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000) tveeprom: audio processor = CX25843 (type = 25) tveeprom: decoder processor = CX25843 (type = 1e) ivtv2: i2c attach to card #2 ok [client=tveeprom, addr=50] tuner (ivtv): chip found at addr 0xc2 i2c-bus ivtv i2c driver #2 ivtv2: i2c attach to card #2 ok [client=(tuner unset), addr=61] cx25840 2-0044: ivtv driver cx25840 2-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #2) cx25840 2-0044: loaded v4l-cx25840.fw firmware (14264 bytes) ivtv2: i2c attach to card #2 ok [client=cx25840, addr=44] wm8775 2-001b: ivtv driver wm8775 2-001b: chip found @ 0x36 (ivtv i2c driver #2) ivtv2: i2c attach to card #2 ok [client=wm8775, addr=1b] ivtv2: This is the second unit of a PVR500 ivtv2: Correcting tveeprom data: no radio present on second unit ivtv2: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) ivtv2: Encoder revision: 0x02050032 ivtv2: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) ivtv2: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total) ivtv2: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total) ivtv2: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total) tuner: type set to 68 (Samsung TCPN 2121P30A) by ivtv i2c driver #2 tuner: switching to v4l2 tuner: tv freq set to 67.25 tuner: tv 0x07 0x10 0xce 0x01 ivtv2: Initialized WinTV PVR 500 (unit #2), card #2 ivtv: ==================== END INIT IVTV ==================== _______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
