Hello, I have just received a PVR-150MCE card and I'm trying to get it working
with my Ubunutu 5.10 install using a 2.6.12-k7 kernel on an nforce2 chipset
mobo, in hopes of gettin a mythtv system running. I have compiled ivtv 0.4.2
and have succesfully loaded the module, but there is no tuner being detected by
default, it gets set to 4. I have tried passing some other tuner numbers to it
in the options from tuner.h, basically 50-55 and 63, and 53 has the best
results but the channels are off and lower channels don't come in at all. I'm
in NTSC land. Is there any hope this exact tuner will be included in a future
version? Here is my related ivtv output from dmesg:
[4294690.931000] ivtv: ==================== START INIT IVTV
====================
[4294690.931000] ivtv: version 0.4.2 (tagged release) loading
[4294690.931000] ivtv: Linux version: 2.6.12-10-k7 K7 gcc-3.4
[4294690.931000] ivtv: In case of problems please include the debug info
between
[4294690.931000] ivtv: the START INIT IVTV and END INIT IVTV lines, along with
[4294690.931000] ivtv: any module options, when mailing the ivtv-users
mailinglist.
[4294690.935000] ivtv0: Autodetected WinTV PVR 150 card (cx23416 based)
[4294690.935000] ACPI: PCI Interrupt Link [APC2] enabled at IRQ 17
[4294690.935000] ACPI: PCI Interrupt 0000:01:07.0[A] -> Link [APC2] -> GSI 17
(level, high) -> IRQ 17
[4294690.935000] ivtv0: Unreasonably low latency timer, setting to 64 (was 32)
[4294690.990000] tveeprom: ivtv version
[4294690.990000] tveeprom: Hauppauge: model = 26552, rev = F0A3, serial# =
8919650
[4294690.990000] tveeprom: tuner = TCL MFNM05-4 (idx = 103, type = 4)
[4294690.990000] tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 =
0x00001000)
[4294690.990000] tveeprom: audio processor = CX25843 (type = 25)
[4294690.990000] tveeprom: decoder processor = CX25843 (type = 1e)
[4294690.990000] ivtv0: i2c attach to card #0 ok [client=tveeprom, addr=50]
[4294691.008000] tuner (ivtv): chip found at addr 0xc2 i2c-bus ivtv i2c driver
#0
[4294691.008000] ivtv0: i2c attach to card #0 ok [client=(tuner unset), addr=61]
[4294691.238000] cx25840 0-0044: ivtv driver
[4294691.238000] cx25840 0-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #0)
[4294694.965000] cx25840 0-0044: loaded v4l-cx25840.fw firmware (14264 bytes)
[4294695.037000] ivtv0: i2c attach to card #0 ok [client=cx25840, addr=44]
[4294695.077000] wm8775 0-001b: ivtv driver
[4294695.077000] wm8775 0-001b: chip found @ 0x36 (ivtv i2c driver #0)
[4294695.087000] ivtv0: i2c attach to card #0 ok [client=wm8775, addr=1b]
[4294695.105000] tda9887 0-0043: (ivtv) chip found @ 0x86 (ivtv i2c driver #0)
[4294695.105000] ivtv0: i2c attach to card #0 ok [client=tda9887, addr=43]
[4294695.806000] ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes)
[4294696.016000] ivtv0: Encoder revision: 0x02050032
[4294696.016000] ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers
(4096KB total)
[4294696.017000] ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers
(2048KB total)
[4294696.018000] ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers
(2048KB total)
[4294696.019000] ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608
buffers (2048KB total)
[4294696.020000] ivtv0: Create encoder radio stream
[4294696.020000] tuner: type set to 53 (Philips FQ1286) by ivtv i2c driver #0
[4294696.240000] ivtv0: Initialized WinTV PVR 150, card #0
[4294696.240000] ivtv: ==================== END INIT IVTV
====================
lspci -v output:
0000:01:07.0 Multimedia video controller: Internext Compression Inc iTVC16
(CX23416) MPEG-2 Encoder (rev 01)
Subsystem: Hauppauge computer works Inc.: Unknown device 8801
Flags: bus master, medium devsel, latency 64, IRQ 17
Memory at d0000000 (32-bit, prefetchable) [size=64M]
Capabilities: [44] Power Management version 2
_______________________________________________
ivtv-users mailing list
[email protected]
http://ivtvdriver.org/mailman/listinfo/ivtv-users
