Following a clean install of 32 bit Mandriva 2006 on a 64 bit AMD machine. I then prepared and installed a Win4lin patched kernel: 2.6.12.mm.1mdkcustom kernel, followed by ivtv-0.4.5. The Howto was carefully followed but the resultant dmesg lists 5 warnings (see listing). Has anyone any idea what is responsible?
[EMAIL PROTECTED] alan]# dmesg|grep ivtv ivtv: ==================== START INIT IVTV ==================== ivtv: version 0.4.5 (tagged release) loading ivtv: Linux version: 2.6.12-12.mm.1mdkcustom preempt K7 gcc-4.0 ivtv: In case of problems please include the debug info between ivtv: the START INIT IVTV and END INIT IVTV lines, along with ivtv: any module options, when mailing the ivtv-users mailinglist. ivtv0: Autodetected WinTV PVR 250 card (cx23415 based) ivtv0: Unreasonably low latency timer, setting to 64 (was 32) tveeprom: ivtv version ivtv0: i2c attach to card #0 ok [client=tveeprom, addr=50] tuner (ivtv): chip found at addr 0xc2 i2c-bus ivtv i2c driver #0 ivtv0: i2c attach to card #0 ok [client=(tuner unset), addr=61] ivtv0 warning: i2c client addr: 0x21 not found for command 0x8004646b! msp3400 0-0040: ivtv driver ivtv0: i2c attach to card #0 ok [client=MSP3415G-B8, addr=40] ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) ivtv0: loaded v4l-cx2341x-dec.fw firmware (262144 bytes) ivtv0: Encoder revision: 0x02050032 ivtv0: Decoder revision: 0x01120002 ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) ivtv0: Allocate DMA encoder YUV stream: 161 x 12960 buffers (2048KB total) ivtv0: Allocate DMA encoder VBI stream: 80 x 26208 buffers (2048KB total) ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total) ivtv0: Create encoder radio stream tuner: type set to 1 (Philips PAL_I (FI1246 and compatibles)) by ivtv i2c drive r #0 ivtv0 warning: i2c client addr: 0x21 not found for command 0x40085618! ivtv0 warning: i2c client addr: 0x21 not found for command 0xc0045627! ivtv0 warning: i2c client addr: 0x21 not found for command 0x40085618! ivtv0 warning: i2c client addr: 0x21 not found for command 0x40045613! ivtv0 warning: i2c client addr: 0x21 not found for command 0x40045612! ivtv0: Initialized WinTV PVR 250, card #0 ivtv: ==================== END INIT IVTV ==================== [EMAIL PROTECTED] alan]# Oddly, if I boot under the original kernel, dmesg reports it as ivtv-0.2.0 plus some sub version letters. Alan Secker _______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
