On Thursday 01 June 2006 18:43, Marcel Janssen wrote:
> On Thursday 01 June 2006 18:30, Marcel Janssen wrote:
> > I set the debug option, but I think the info below doesn't provide
> > much. The firmware failed to load again for some reason. I'll try
> > to get more info later.
>
> Got some more info attached. I hope it helps.
> I don't understand the 400Mhz setting being later reported as 0.4Mhz,
> which is out of range. Perhaps this gives a clue to what is going
> wrong.
Ah, thanks! This did indeed give me the clue I needed. The type field of
the v4l2_frequency struct was left uninitialized in the ivtv driver
when the frequency was set on driver load. So if you were unlucky it
would switch the tuner to radio mode. It's now fixed in the subversion
repository.
Thanks again for doing the testing,
Hans
>
> regards,
> Marcel
>
> ivtv: ==================== START INIT IVTV ====================
> ivtv: version 0.6.2 (development snapshot compiled on Mon May 8
> 07:35:43 2006) loading
> ivtv: Linux version: 2.6.16-1.2111_FC5 686 REGPARM 4KSTACKS gcc-4.1
> ivtv: In case of problems please include the debug info between
> ivtv: the START INIT IVTV and END INIT IVTV lines, along with
> ivtv: any module options, when mailing the ivtv-users mailinglist.
> ivtv0: Autodetected Hauppauge WinTV PVR-350 card (cx23415 based)
> ACPI: PCI Interrupt 0000:00:0d.0[A] -> GSI 16 (level, low) -> IRQ 18
> tveeprom 4-0050: Hauppauge model 48134, rev J347, serial# 7110286
> tveeprom 4-0050: tuner model is LG TP18PSB01D (idx 47, type 28)
> tveeprom 4-0050: TV standards PAL(B/G) (eeprom 0x04)
> tveeprom 4-0050: audio processor is MSP4418 (idx 25)
> tveeprom 4-0050: decoder processor is SAA7115 (idx 19)
> tveeprom 4-0050: has radio, has IR remote
> tuner: tuner_debug is deprecated and will be removed in 2.6.17.
> tuner: use the debug option instead.
> tuner 4-0061: Setting mode_mask to 0x0e
> tuner 4-0061: chip found @ 0xc2 (ivtv i2c driver #0)
> tuner 4-0061: tuner 0x61: Tuner type absent
> saa7115 4-0021: saa7115 found @ 0x42 (ivtv i2c driver #0)
> saa7127 4-0044: saa7127 found @ 0x88 (ivtv i2c driver #0)
> msp3400 4-0040: MSP4418G-A2 found @ 0x80 (ivtv i2c driver #0)
> msp3400 4-0040: MSP4418G-A2 supports nicam and radio, mode is
> autodetect and autoselect
> ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes)
> ivtv0: loaded v4l-cx2341x-dec.fw firmware (262144 bytes)
> ivtv0: Encoder revision: 0x02050032
> ivtv0: Decoder revision: 0x02020023
> ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB
> total) ivtv0: Allocate DMA encoder YUV stream: 161 x 12960 buffers
> (2048KB total) ivtv0: Allocate DMA encoder VBI stream: 80 x 26208
> buffers (2048KB total) ivtv0: Allocate DMA encoder PCM audio stream:
> 455 x 4608 buffers (2048KB total)
> ivtv0: Create encoder radio stream
> ivtv0: Allocate DMA decoder MPEG stream: 16 x 65536 buffers (1024KB
> total) ivtv0: Allocate DMA decoder VBI stream: 512 x 2048 buffers
> (1024KB total) ivtv0: Create decoder VOUT stream
> ivtv0: Allocate DMA decoder YUV stream: 20 x 51840 buffers (1024KB
> total) ivtv0: loaded v4l-cx2341x-init.mpg firmware (155648 bytes)
> tuner 4-0061: Calling set_type_addr for type=28, addr=0xff, mode=0x04
> tuner 4-0061: type set to 28 (LG PAL_BG+FM (TPI8PSB01D))
> tuner 4-0061: ivtv i2c driver #0 tuner I2C addr 0xc2 with type 28
> used for 0x0e
> tuner 4-0061: Cmd VIDIOC_S_STD accepted for analog TV
> tuner 4-0061: switching to v4l2
> tuner 4-0061: tv freq set to 400.00
> tuner 4-0061: tv: range 1
> tuner 4-0061: Freq= 400.00 MHz, V_IF=38.93 MHz, Offset=0.00 MHz,
> div=7023 tuner 4-0061: tv 0x1b 0x6f 0x8e 0x90
> tuner 4-0061: Cmd VIDIOC_S_FREQUENCY accepted for radio
> tuner 4-0061: radio freq set to 0.40
> tuner 4-0061: radio freq (0.40) out of range (65-108)
> tuner 4-0061: radio 0x05 0xea 0x88 0xa5
> ivtv0: Initialized Hauppauge WinTV PVR-350, card #0
> ivtv: ==================== END INIT IVTV ====================
> ivtv0: ================= START STATUS CARD #0 =================
> tveeprom 4-0050: Hauppauge model 48134, rev J347, serial# 7110286
> tveeprom 4-0050: tuner model is LG TP18PSB01D (idx 47, type 28)
> tveeprom 4-0050: TV standards PAL(B/G) (eeprom 0x04)
> tveeprom 4-0050: audio processor is MSP4418 (idx 25)
> tveeprom 4-0050: decoder processor is SAA7115 (idx 19)
> tveeprom 4-0050: has radio, has IR remote
> tuner 4-0061: Tuner mode: radio
> tuner 4-0061: Frequency: 0.40 MHz
> tuner 4-0061: Standard: 0x000000ff
> tuner 4-0061: Signal strength: 16384
> tuner 4-0061: Stereo: no
> saa7115 4-0021: Audio frequency: 48000 Hz
> saa7115 4-0021: Input: Composite 4
> saa7115 4-0021: Video signal: bad
> saa7115 4-0021: Frequency: 50 Hz
> saa7115 4-0021: Detected format: BW/No color
> saa7127 4-0044: Standard: 50 Hz
> saa7127 4-0044: Input: normal
> saa7127 4-0044: Output: S-Video + Composite
> saa7127 4-0044: WSS: disabled
> saa7127 4-0044: VPS: disabled
> saa7127 4-0044: CC: disabled
> msp3400 4-0040: MSP4418G-A2 rev1 = 0x0117 rev2 = 0x1242
> msp3400 4-0040: Audio: volume 58880
> msp3400 4-0040: Mode: AM (for carrier detect)
> msp3400 4-0040: Standard: could not detect sound standard (mono)
> msp3400 4-0040: ACB: 0x0c00
> ivtv0: ================== END STATUS CARD #0 ==================
_______________________________________________
ivtv-users mailing list
[email protected]
http://ivtvdriver.org/mailman/listinfo/ivtv-users
