Hello, I have a Hauppauge wintv-pvr-250 MCE that is not being correctly recognized. I have attached the info from dmesg below. I have also listed the installed versions of ivtv software. Please advise. I'm stuck in a state where mythtv is not picking up any analog input from the tuner. Thank you.
ivtv.i386 1:0.6.2-110.rhfc4.at installed ivtv-firmware.noarch 2:1.8a-10.at installed ivtv-kmdl-2.6.16-1.2111_FC4.i686 1:0.6.2-110.rhfc4.at installed perl-Video-ivtv.i386 0.13-7.rhfc4.at installed ivtv: no version for "struct_module" found: kernel tainted. ivtv: ==================== START INIT IVTV ==================== ivtv: version 0.6.2 (development snapshot compiled on Mon May 22 01:15:49 2006) loading ivtv: Linux version: 2.6.16-1.2111_FC4 686 REGPARM 4KSTACKS gcc-4.0 ivtv: In case of problems please include the debug info between ivtv: the START INIT IVTV and END INIT IVTV lines, along with ivtv: any module options, when mailing the ivtv-users mailinglist. ivtv0: Unknown card: vendor/device: 4444/0016 ivtv0: subsystem vendor/device: 0070/0001 ivtv0: cx23416 based ivtv0: Defaulting to Hauppauge WinTV PVR-150 card ivtv0: Please mail the vendor/device and subsystem vendor/device IDs and what kind of ivtv0: card you have to the ivtv-devel mailinglist (www.ivtvdriver.org) ivtv0: Prefix your subject line with [UNKNOWN CARD]. ACPI: PCI Interrupt 0000:03:02.0[A] -> GSI 17 (level, low) -> IRQ 18 ivtv0: Unreasonably low latency timer, setting to 64 (was 32) tveeprom 2-0050: Hauppauge model 32552, rev C168, serial# 8554149 tveeprom 2-0050: tuner model is LG TAPE H001F MK3 (idx 68, type 47) tveeprom 2-0050: TV standards NTSC(M) (eeprom 0x08) tveeprom 2-0050: audio processor is MSP4448 (idx 27) tveeprom 2-0050: decoder processor is SAA7115 (idx 19) tveeprom 2-0050: has radio, has no IR remote tuner 2-0061: chip found @ 0xc2 (ivtv i2c driver #0) tda9887 2-0043: chip found @ 0x86 (ivtv i2c driver #0) ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) ivtv0: Encoder revision: 0x02050032 ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total) ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total) ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total) ivtv0: Create encoder radio stream tuner 2-0061: type set to 47 (LG NTSC (TAPE series)) ivtv0: i2c hardware 0x00000001 not found for command 0xc008561c! ivtv0: i2c addr 0x44 not found for command 0x40045613! ivtv0: i2c addr 0x44 not found for command 0xc0045627! ivtv0: i2c hardware 0x00000020 not found for command 0x40345622! ivtv0: i2c addr 0x44 not found for command 0x40345622! ivtv0: i2c addr 0x44 not found for command 0x40045612! ivtv0: i2c hardware 0x00000001 not found for command 0xc008561c! ivtv0: i2c hardware 0x00000001 not found for command 0xc008561c! ivtv0: i2c addr 0x44 not found for command 0x40045613! ivtv0: i2c addr 0x44 not found for command 0x40045612! ivtv0: i2c hardware 0x00000001 not found for command 0xc008561c! ivtv0: Initialized Hauppauge WinTV PVR-150, card #0 ivtv: ==================== END INIT IVTV ==================== _______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
