>>>ivtv: ==================== START INIT IVTV ==================== >>>and: >>>ivtv: ==================== END INIT IVTV ==================== >>>is helpful to know when you decide that it isn't working right! >>>Just because the modules are loaded, doesn't mean its working. You >>>could be having 2.6.17 issues, as Axel mentioned. >>Here is my mplayer output: > Where is the information from your system logs????? It will be more
Oh, yeah. Right! :-) Here: > Linux video capture interface: v1.00 > ivtv: no version for "struct_module" found: kernel tainted. > ivtv: ==================== START INIT IVTV ==================== > ivtv: version 0.7.0 (tagged release) loading > ivtv: Linux version: 2.6.17-1.2157_FC5 SMP mod_unload gcc-4.1 > ivtv: In case of problems please include the debug info between > ivtv: the START INIT IVTV and END INIT IVTV lines, along with > ivtv: any module options, when mailing the ivtv-users mailinglist. > eth0: forcedeth.c: subsystem: 0cb84:10de bound to 0000:00:0a.0 > ACPI: PCI Interrupt Link [APCL] enabled at IRQ 20 > GSI 19 sharing vector 0x32 and IRQ 19 > ACPI: PCI Interrupt 0000:00:02.1[B] -> Link [APCL] -> GSI 20 (level, low) -> > IRQ 50 > PCI: Setting latency timer of device 0000:00:02.1 to 64 > ehci_hcd 0000:00:02.1: EHCI Host Controller > ehci_hcd 0000:00:02.1: new USB bus registered, assigned bus number 1 > ehci_hcd 0000:00:02.1: debug port 1 > PCI: cache line size of 64 is not supported by device 0000:00:02.1 > ehci_hcd 0000:00:02.1: irq 50, io mem 0xfeb00000 > ehci_hcd 0000:00:02.1: USB 2.0 started, EHCI 1.00, driver 10 Dec 2004 > usb usb1: configuration #1 chosen from 1 choice > hub 1-0:1.0: USB hub found > hub 1-0:1.0: 10 ports detected > ACPI: PCI Interrupt Link [APCJ] enabled at IRQ 23 > ACPI: PCI Interrupt 0000:00:04.0[A] -> Link [APCJ] -> GSI 23 (level, low) -> > IRQ 217 > PCI: Setting latency timer of device 0000:00:04.0 to 64 > intel8x0_measure_ac97_clock: measured 58610 usecs > intel8x0: clocking to 47019 > ivtv0: Autodetected Hauppauge WinTV PVR-350 card (cx23415 based) > ACPI: PCI Interrupt Link [APCF] enabled at IRQ 22 > ACPI: PCI Interrupt 0000:00:02.0[A] -> Link [APCF] -> GSI 22 (level, low) -> > IRQ 225 > PCI: Setting latency timer of device 0000:00:02.0 to 64 > ohci_hcd 0000:00:02.0: OHCI Host Controller > ohci_hcd 0000:00:02.0: new USB bus registered, assigned bus number 2 > ohci_hcd 0000:00:02.0: irq 225, io mem 0xfebff000 > ACPI: PCI Interrupt Link [APC1] enabled at IRQ 16 > GSI 20 sharing vector 0x3A and IRQ 20 > ACPI: PCI Interrupt 0000:01:08.0[A] -> Link [APC1] -> GSI 16 (level, low) -> > IRQ 58 > ivtv0: Unreasonably low latency timer, setting to 64 (was 32) > tveeprom 2-0050: Hauppauge model 48132, rev K268, serial# 8083237 > tveeprom 2-0050: tuner model is LG TAPE H001F MK3 (idx 68, type 47) > tveeprom 2-0050: TV standards NTSC(M) (eeprom 0x08) > tveeprom 2-0050: audio processor is MSP4448 (idx 27) > tveeprom 2-0050: decoder processor is SAA7115 (idx 19) > tveeprom 2-0050: has radio, has IR remote > usb usb2: configuration #1 chosen from 1 choice > hub 2-0:1.0: USB hub found > hub 2-0:1.0: 10 ports detected > tuner 2-0061: chip found @ 0xc2 (ivtv i2c driver #0) > tda9887 2-0043: chip found @ 0x86 (ivtv i2c driver #0) > saa7115 2-0021: saa7115 found @ 0x42 (ivtv i2c driver #0) > saa7127 2-0044: saa7129 found @ 0x88 (ivtv i2c driver #0) > msp3400 2-0040: MSP4448G-A2 found @ 0x80 (ivtv i2c driver #0) > msp3400 2-0040: MSP4448G-A2 supports radio, mode is autodetect and autoselect > ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) > ivtv0: loaded v4l-cx2341x-dec.fw firmware (262144 bytes) > ivtv0: Encoder revision: 0x02050032 > ivtv0: Decoder revision: 0x02020023 > ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) > ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total) > ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total) > ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB > total) > ivtv0: Create encoder radio stream > ivtv0: Allocate DMA decoder MPEG stream: 16 x 65536 buffers (1024KB total) > ivtv0: Allocate DMA decoder VBI stream: 512 x 2048 buffers (1024KB total) > ivtv0: Create decoder VOUT stream > ivtv0: Allocate DMA decoder YUV stream: 24 x 43200 buffers (1024KB total) > ivtv0: loaded v4l-cx2341x-init.mpg firmware (155648 bytes) > tuner 2-0061: type set to 47 (LG NTSC (TAPE series)) > ivtv0: Initialized Hauppauge WinTV PVR-350, card #0 > ivtv: ==================== END INIT IVTV ====================
signature.asc
Description: OpenPGP digital signature
_______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
