my new notebook has an AverMedia M104 (http://www.avermedia.com/cgi-bin/products_odm_M104.asp) for a TV card,
which I'm now trying to get to work. The ivtv driver appears to load fine and
mplayer shows a black image at /dev/video0, but tuning through either scantv
or ivtv-tune doesn't yield any results. Also, there is no /dev/radio present.
Here's the dmesg and lspci output:
---<snip dmesg>---
[17179591.440000] ivtv: ==================== START INIT IVTV ====================
[17179591.440000] ivtv: version 0.4.6 (tagged release) loading
[17179591.440000] ivtv: Linux version: 2.6.15-26-686 SMP preempt 686 gcc-4.0
[17179591.440000] ivtv: In case of problems please include the debug info between
[17179591.440000] ivtv: the START INIT IVTV and END INIT IVTV lines, along with
[17179591.440000] ivtv: any module options, when mailing the ivtv-users mailinglist.
[17179591.628000] ivtv0: Unknown card: vendor/device: 4444/0016
[17179591.628000] ivtv0: subsystem vendor/device: 1461/c136
[17179591.628000] ivtv0: cx23416 based
[17179591.628000] ivtv0: Defaulting to WinTV PVR 150 card
[17179591.628000] ivtv0: Please mail the vendor/device and subsystem vendor/device IDs and what kind of
[17179591.628000] ivtv0: card you have to the ivtv-devel mailinglist (www.ivtvdriver.org )
[17179591.628000] ivtv0: Prefix your subject line with [UNKNOWN CARD].
[17179591.740000] ivtv0 warning: i2c client addr: 0x50 not found for command 0x0!
[17179591.740000] ivtv0: Error -19 reading Hauppauge eeprom.
[17179591.740000] ivtv0: Possible causes: the tveeprom module was not loaded, or
[17179591.740000] ivtv0: the eeprom kernel module was loaded before the tveeprom module.
[17179591.780000] tuner (ivtv): chip found at addr 0xc2 i2c-bus ivtv i2c driver #0
[17179591.780000] ivtv0: i2c attach to card #0 ok [client=(tuner unset), addr=61]
[17179592.004000] cx25840 0-0044: ivtv driver
[17179592.004000] cx25840 0-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #0)
[ 17179596.504000] ivtv0: i2c attach to card #0 ok [client=cx25840, addr=44]
[17179596.612000] ivtv0: Could not detect tuner standard, defaulting to NTSC.
[17179597.268000] ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes)
[17179597.488000] ivtv0: Encoder revision: 0x02050032
[17179597.488000] ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total)
[17179597.488000] ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total)
[17179597.488000] ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total)
[17179597.488000] ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total)
[17179597.528000] ivtv0 warning: i2c client addr: 0x1b not found for command 0x40046d11!
[17179597.576000] ivtv0 warning: i2c client addr: 0x1b not found for command 0x402c5639!
[17179597.588000] ivtv0: Initialized WinTV PVR 150, card #0
[17179597.740000] ivtv: ==================== END INIT IVTV ====================
---<snap>---
---<snip lspci>---
0000:03:02.0 Multimedia video controller: Internext Compression Inc iTVC16 (CX23416) MPEG-2 Encoder (rev 01)
Subsystem: Avermedia Technologies Inc: Unknown device c136
Flags: bus master, medium devsel, latency 64, IRQ 209
Memory at d8000000 (32-bit, prefetchable) [size=64M]
Capabilities: [44] Power Management version 2
---<snap>---
I tried with both the shipped antenna and cable attached to the notebook.
Any hints or pointers would be greatly appreciated :-)
Best regards,
Raphael Schmid
--
Raphael J. Schmid
Carl-Maria-von-Weber-Strasse 26
71083 Herrenberg
Mobile: +49(0)173-8757046
[EMAIL PROTECTED]
http://schattenschreiber.org
NIETS IS ONMOGELIJK!
_______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
