I have a problem with pvr150. I use fedora core 5 latest kernel 2.6.17-1.2174_FC5 with ivtv from atrpms.
If I capture from the card, it sounds distorting.
I have tested other pvr150 cards, same problem. much more distorting, in particulars fell somewhat less distorting.
the same cards on an old partition with Fedora Core 4 an ivtv 0.3.7 works good.
I have never idea what I can do.
here some logs:
==================== START INIT IVTV ====================
ivtv: version 0.7.0 (tagged release) loading
ivtv: Linux version: 2.6.17-1.2174_FC5 mod_unload 586 REGPARM 4KSTACKS gcc-4.1
ivtv: In case of problems please include the debug info between
ivtv: the START INIT IVTV and END INIT IVTV lines, along with
ivtv: any module options, when mailing the ivtv-users mailinglist.
ivtv0: Autodetected Hauppauge WinTV PVR-150 card (cx23416 based)
ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 7
PCI: setting IRQ 7 as level-triggered
ACPI: PCI Interrupt 0000:00:14.0[A] -> Link [LNKB] -> GSI 7 (level, low) -> IRQ 7
ivtv0: Unreasonably low latency timer, setting to 64 (was 32)
tveeprom 0-0050: The eeprom says no radio is present, but the tuner type
tveeprom 0-0050: indicates otherwise. I will assume that radio is present.
tveeprom 0-0050: Hauppauge model 26559, rev C260, serial# 8224862
tveeprom 0-0050: tuner model is LG S001D MK3 (idx 60, type 38)
tveeprom 0-0050: TV standards PAL(B/G) PAL(I) SECAM(L/L') PAL(D/D1/K) (eeprom 0x74)
tveeprom 0-0050: audio processor is CX25843 (idx 37)
tveeprom 0-0050: decoder processor is CX25843 (idx 30)
tveeprom 0-0050: has radio, has no IR remote
tuner 0-0061: chip found @ 0xc2 (ivtv i2c driver #0)
tda9887 0-0043: chip found @ 0x86 (ivtv i2c driver #0)
cx25840 0-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #0)
NET: Registered protocol family 23
via-rhine.c:v1.10-LK1.2.0-2.6 June-10-2004 Written by Donald Becker
USB Universal Host Controller Interface driver v3.0
cx25840 0-0044: loaded v4l-cx25840.fw firmware (16382 bytes)
wm8775 0-001b: chip found @ 0x36 (ivtv i2c driver #0)
ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes)
ivtv0: Encoder revision: 0x02050032
ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total)
ivtv0: Allocate DMA encoder YUV stream: 161 x 12960 buffers (2048KB total)
ivtv0: Allocate DMA encoder VBI stream: 80 x 26208 buffers (2048KB total)
ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total)
ivtv0: Create encoder radio stream
tuner 0-0061: type set to 38 (Philips PAL/SECAM multi (FM1216ME MK3))
ivtv0: Initialized Hauppauge WinTV PVR-150, card #0
ACPI: PCI Interrupt 0000:00:12.0[A] -> Link [LNKA] -> GSI 5 (level, low) -> IRQ 5
eth0: VIA Rhine II at 0xee000000, 00:40:63:d6:46:81, IRQ 5.
eth0: MII PHY found at address 1, status 0x786d advertising 05e1 Link c1e1.
ACPI: PCI Interrupt 0000:00:10.0[A] -> Link [LNKA] -> GSI 5 (level, low) -> IRQ 5
uhci_hcd 0000:00:10.0: UHCI Host Controller
uhci_hcd 0000:00:10.0: new USB bus registered, assigned bus number 1
uhci_hcd 0000:00:10.0: irq 5, io base 0x0000d000
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
ivtv: ==================== END INIT IVTV ====================
lspci -v
00:14.0 Multimedia video controller: Internext Compression Inc iTVC16 (CX23416) MPEG-2 Encoder (rev 01)
Subsystem: Hauppauge computer works Inc. Unknown device 8801
Flags: bus master, medium devsel, latency 64, IRQ 7
Memory at e8000000 (32-bit, prefetchable) [size=64M]
Capabilities: [44] Power Management version 2
I hope someone can help me to solve the problem
thanx ks
Yahoo! Messenger - kostenlos* mit Familie und Freunden von PC zu PC telefonieren .
_______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
