On Monday 11 September 2006 23:53, Petter Sundlöf wrote:
> Hans Verkuil wrote:
> > On Monday 11 September 2006 23:08, Petter Sundlöf wrote:
> >> I'm getting no audio when using my Hauppauge PVR 150 (non-MCE).
> >>
> >> I've tried 2.6.15 and 0.4, and both pvr_1.18.21.22254_inf.zip and
> >> pvr_1.18.21.22301_inf.zip firmwares. I'm using tuner=50 for the
> >> ivtv
> >
> > Use tuner=55. Tuner 50 is for NTSC, tuner 55 is for PAL. It will
> > work a lot better after that change :-)
> >
> > Hans
>
> Unfortunately this doesn't affect audio. The video still looks the
> same as with 50.
You did disable the pvr150_workaround, did you? If it's enabled, then it
will force the cx2584x to NTSC, which is not what you want.
If you still have problems, then please post the INIT IVTV messages from
the kernel log.
Hans
>
> >> module. With kernel 2.6.17 I am using 0.7, and have tried both of
> >> the above mentioned firmware versions.
> >>
> >> I also tried patching ivtv-driver.c according to jstew's (a
> >> friendlt person in #mythtv-users) to enable the pvr150_workaround.
> >> (adding another itv->pvr150_workaround = 1; at row 515)
> >>
> >> mplayer reports
> >>
> >> AO: [alsa] 48000Hz 2ch s16le (2 bytes per sample).
> >>
> >> I've also tried fiddling with ivtvctl.
> >>
> >> ivtvctl --set-ctrl=mute=0 -d /dev/video0
> >>
> >> has no effect
> >>
> >> But after I do ivtvctl --set-audio-input 1
> >>
> >> I get some random clicks in both channels, alternating between
> >> left and right. Only when I set it to 1, ivtvctl --log-status says
> >> " cx25840 0-0044: Audio muted: no". But it also says
> >> " cx25840 0-0044: Audio microcontroller: stopped"
> >> With 0 it says Muted: yes, but Running.
> >>
> >> Here's the full output of ivtvctl --log-status as it appears on a
> >> default boot:
> >>
> >> (23:07:36) [EMAIL PROTECTED]:~$ ivtvctl --log-status
> >> ioctl VIDIOC_LOG_STATUS ok
> >> ivtv0: ================= START STATUS CARD #0
> >> ================= tveeprom 0-0050: Hauppauge model 26034, rev
> >> C1B3, serial# 8823954 tveeprom 0-0050: tuner model is TCL
> >> M2523_3DB_E (idx 113, type 4) tveeprom 0-0050: TV standards
> >> PAL(B/G) PAL(D/D1/K) (eeprom 0x44) tveeprom 0-0050: audio
> >> processor is CX25842 (idx 36)
> >> tveeprom 0-0050: decoder processor is CX25842 (idx 29)
> >> tveeprom 0-0050: has no radio, has IR remote
> >> tuner 0-0061: Tuner mode: analog TV
> >> tuner 0-0061: Frequency: 203.25 MHz
> >> tuner 0-0061: Standard: 0x000000ff
> >> cx25840 0-0044: Video signal: present
> >> cx25840 0-0044: Detected format: PAL-BDGHI
> >> cx25840 0-0044: Detected audio mode: mono
> >> cx25840 0-0044: Detected audio standard: not defined
> >> cx25840 0-0044: Audio muted: yes
> >> cx25840 0-0044: Audio microcontroller: running
> >> cx25840 0-0044: Configured audio standard: automatic detection
> >> cx25840 0-0044: Configured audio system: automatic standard
> >> and mode detection
> >> cx25840 0-0044: Specified standard: PAL-BDGHI
> >> cx25840 0-0044: Specified video input: Composite 7
> >> cx25840 0-0044: Specified audio input: Tuner (In8)
> >> cx25840 0-0044: Specified audioclock freq: 48000 Hz
> >> cx25840 0-0044: Preferred audio mode: stereo
> >> cx25840 0-0044: Selected 65 MHz format: autodetect
> >> cx25840 0-0044: Selected 45 MHz format: chroma
> >> wm8775 0-001b: Input: 2
> >> ivtv0: ================== END STATUS CARD #0
> >> ==================
> >>
> >> Any help would be greatly appreciated.
> >>
> >> Best regards,
> >> Petter Sundlöf
> >>
> >> _______________________________________________
> >> ivtv-users mailing list
> >> [email protected]
> >> http://ivtvdriver.org/mailman/listinfo/ivtv-users
> >
> > _______________________________________________
> > ivtv-users mailing list
> > [email protected]
> > http://ivtvdriver.org/mailman/listinfo/ivtv-users
>
> _______________________________________________
> ivtv-users mailing list
> [email protected]
> http://ivtvdriver.org/mailman/listinfo/ivtv-users
_______________________________________________
ivtv-users mailing list
[email protected]
http://ivtvdriver.org/mailman/listinfo/ivtv-users
