|
Hi, Trying to setup a PVR350, but the tuner is a Philips
FM1216ME MK5. Im using Debian Etch with a 2.6.16-2-686 kernel. Im getting the error “Tuner type not set” and
only static if I try and capture/view /dev/video0 Ive had a look at the patches for tveeprom, but although it
mentions the tuner in the struct, it seems to assign TUNER_ABSENT. Ive tried using tuner options of 1, 5, 38 and 56, but with
no success. The output below is where I was trying to find a similar
tuner – otherwise it chooses type 4. Any suggestions? Thanks, Jim ivtv: ==================== START INIT IVTV
==================== ivtv: version 0.6.3 (tagged release) loading ivtv: Linux version: 2.6.16-2-686 686 gcc-4.0 ivtv: In case of problems please include the debug
info between ivtv: the START INIT IVTV and END INIT IVTV
lines, along with ivtv: any module options, when mailing the
ivtv-users mailinglist. ivtv0:
Autodetected Hauppauge WinTV PVR-350 card (cx23415 based) ACPI:
PCI Interrupt 0000:02:01.0[A] -> GSI 21 (level, low) -> IRQ 217 tuner
1-0061: chip found @ 0xc2 (ivtv i2c driver #0) tda9887
1-0043: chip found @ 0x86 (ivtv i2c driver #0) saa7115
1-0021: saa7115 found @ 0x42 (ivtv i2c driver #0) saa7127
1-0044: saa7129 found @ 0x88 (ivtv i2c driver #0) msp3400
1-0040: MSP4418G-B3 found @ 0x80 (ivtv i2c driver #0) msp3400
1-0040: MSP4418G-B3 supports nicam and radio, mode is autodetect and autoselect tveeprom
1-0050: Hauppauge model 48139, rev K2B7, serial# 8889475 tveeprom
1-0050: tuner model is Philips FM1216ME MK5 (idx 117, type 4) tveeprom
1-0050: TV standards PAL(B/G) PAL(I) SECAM(L/L') PAL(D/D1/K) (eeprom 0x74) tveeprom
1-0050: audio processor is MSP4418 (idx 25) tveeprom
1-0050: decoder processor is SAA7115 (idx 19) tveeprom
1-0050: has radio, has IR remote ivtv0:
loaded v4l-cx2341x-enc.fw firmware (262144 bytes) ivtv0:
loaded v4l-cx2341x-dec.fw firmware (262144 bytes) ivtv0:
Encoder revision: 0x02050032 ivtv0:
Decoder revision: 0x02020023 ivtv0:
Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) ivtv0:
Allocate DMA encoder YUV stream: 161 x 12960 buffers (2048KB total) ivtv0:
Allocate DMA encoder VBI stream: 80 x 26208 buffers (2048KB total) ivtv0:
Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total) ivtv0:
Create encoder radio stream ivtv0:
Allocate DMA decoder MPEG stream: 16 x 65536 buffers (1024KB total) ivtv0:
Allocate DMA decoder VBI stream: 512 x 2048 buffers (1024KB total) ivtv0:
Create decoder VOUT stream ivtv0:
Allocate DMA decoder YUV stream: 20 x 51840 buffers (1024KB total) ivtv0:
loaded v4l-cx2341x-init.mpg firmware (155648 bytes) tuner
1-0061: type set to 56 (Philips PAL/SECAM multi (FQ1216AME MK4)) ivtv0:
Initialized Hauppauge WinTV PVR-350, card #0 ivtv: ==================== END INIT IVTV ==================== agpgart:
Found an AGP 3.0 compliant device at 0000:00:00.0. agpgart:
Device is in legacy mode, falling back to 2.x agpgart:
Putting AGP V2 device at 0000:00:00.0 into 1x mode agpgart:
Putting AGP V2 device at 0000:01:00.0 into 1x mode |
_______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
