Help! I upgraded my system to 2.6.18-1.2200.fc5 and installed the cooresponding kernel module from ATrpms. However, when I boot, it says that it can't load the tda9887 module. Not sure what to do from here... how do I diagnose/resolve this?
I have to Hauppauge cards installed: a 350 and a 500. Here's the relevant section of my boot log: ivtv: ==================== START INIT IVTV ==================== ivtv: version 0.7.1 (tagged release) loading ivtv: Linux version: 2.6.18-1.2200.fc5 mod_unload 686 REGPARM 4KSTACKS gcc-4.1 ivtv: In case of problems please include the debug info between ivtv: the START INIT IVTV and END INIT IVTV lines, along with ivtv: any module options, when mailing the ivtv-users mailinglist. ivtv0: Autodetected Hauppauge WinTV PVR-350 card (cx23415 based) ACPI: PCI Interrupt Link [LNKG] enabled at IRQ 7 PCI: setting IRQ 7 as level-triggered ACPI: PCI Interrupt 0000:02:0a.0[A] -> Link [LNKG] -> GSI 7 (level, low) -> IRQ 7 tveeprom 1-0050: The eeprom says no radio is present, but the tuner type tveeprom 1-0050: indicates otherwise. I will assume that radio is present. tveeprom 1-0050: Hauppauge model 48132, rev K268, serial# 8230111 tveeprom 1-0050: tuner model is LG TAPE H001F MK3 (idx 68, type 47) tveeprom 1-0050: TV standards NTSC(M) (eeprom 0x08) tveeprom 1-0050: audio processor is MSP4448 (idx 27) tveeprom 1-0050: decoder processor is SAA7115 (idx 19) tveeprom 1-0050: has radio, has IR remote via-rhine.c:v1.10-LK1.4.1 July-24-2006 Written by Donald Becker nvidia: module license 'NVIDIA' taints kernel. tuner 1-0043: chip found @ 0x86 (ivtv i2c driver #0) tda9887 1-0043: tda988[5/6/7] found @ 0x43 (tuner) tuner 1-0061: chip found @ 0xc2 (ivtv i2c driver #0) ivtv0: Failed to load module tda9887 saa7115 1-0021: saa7115 found @ 0x42 (ivtv i2c driver #0) saa7127 1-0044: saa7129 found @ 0x88 (ivtv i2c driver #0) msp3400 1-0040: MSP4448G-A2 found @ 0x80 (ivtv i2c driver #0) msp3400 1-0040: MSP4448G-A2 supports radio, mode is autodetect and autoselect USB Universal Host Controller Interface driver v3.0 ieee1394: Initialized config rom entry `ip1394' Floppy drive(s): fd0 is 1.44M FDC 0 is a post-1991 82077 ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) ivtv0: loaded v4l-cx2341x-dec.fw firmware (262144 bytes) ivtv0: Encoder revision: 0x02050032 ivtv0: Decoder revision: 0x02020023 ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total) ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total) ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total) ivtv0: Create encoder radio stream ivtv0: Allocate DMA decoder MPEG stream: 16 x 65536 buffers (1024KB total) ivtv0: Allocate DMA decoder VBI stream: 512 x 2048 buffers (1024KB total) ivtv0: Create decoder VOUT stream ivtv0: Allocate DMA decoder YUV stream: 24 x 43200 buffers (1024KB total) ivtv0: loaded v4l-cx2341x-init.mpg firmware (155648 bytes) tuner 1-0061: type set to 47 (LG NTSC (TAPE series)) ivtv0: Initialized Hauppauge WinTV PVR-350, card #0 ivtv: ====================== NEXT CARD ====================== ivtv1: Autodetected Hauppauge WinTV PVR-150 card (cx23416 based) ACPI: PCI Interrupt Link [LNKH] enabled at IRQ 4 PCI: setting IRQ 4 as level-triggered ACPI: PCI Interrupt 0000:03:08.0[A] -> Link [LNKH] -> GSI 4 (level, low) -> IRQ 4 tuner 2-0043: chip found @ 0x86 (ivtv i2c driver #1) tda9887 2-0043: tda988[5/6/7] found @ 0x43 (tuner) tuner 2-0060: TEA5767 detected. tuner 2-0060: chip found @ 0xc0 (ivtv i2c driver #1) tuner 2-0060: type set to 62 (Philips TEA5767HN FM Radio) tuner 2-0061: chip found @ 0xc2 (ivtv i2c driver #1) tveeprom 2-0050: Hauppauge model 23552, rev D592, serial# 8321049 tveeprom 2-0050: tuner model is Philips FQ1236A MK4 (idx 92, type 57) tveeprom 2-0050: TV standards NTSC(M) (eeprom 0x08) tveeprom 2-0050: second tuner model is Philips TEA5768HL FM Radio (idx 101, type 62) tveeprom 2-0050: audio processor is CX25843 (idx 37) tveeprom 2-0050: decoder processor is CX25843 (idx 30) tveeprom 2-0050: has radio, has no IR remote ivtv1: This is the first unit of a PVR500 ivtv1: Failed to load module tda9887 cx25840 2-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #1) cx25840 2-0044: loaded v4l-cx25840.fw firmware (16382 bytes) wm8775 2-001b: chip found @ 0x36 (ivtv i2c driver #1) ivtv1: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) ivtv1: Encoder revision: 0x02050032 ivtv1: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) ivtv1: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total) ivtv1: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total) ivtv1: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total) ivtv1: Create encoder radio stream tuner 2-0061: type set to 57 (Philips FQ1236A MK4) ivtv1: Initialized WinTV PVR 500 (unit #1), card #1 ACPI: PCI Interrupt 0000:02:0c.0[A] -> Link [LNKB] -> GSI 9 (level, low) -> IRQ 9 ivtv: ==================== END INIT IVTV ==================== ivtv0-osd: Framebuffer module loaded (attached to ivtv card id 0) ACPI: PCI Interrupt 0000:02:0c.2[B] -> Link [LNKF] -> GSI 3 (level, low) -> IRQ 3 ohci1394: fw-host0: OHCI-1394 1.1 (PCI): IRQ=[3] MMIO=[feafe000-feafe7ff] Max Packet=[2048] IR/IT contexts=[4/8] ivtv0-osd: screen coords: [0 0] -> [720 480] ivtv0-osd: original global alpha = 208 ivtv0-osd: current OSD state = 39 ivtv0-osd: new global alpha = 208 (1 255 0) ivtv0-osd: framebuffer at 0xf1510000, mapped to 0xe1a10000, size 1665k ivtv0-osd: mode is 720x480x32, linelength=2880 ivtv0-osd: fb1: cx23415 TV out frame buffer device ivtv0: Allocate DMA decoder OSD stream: 16 x 65536 buffers (1024KB total) usb 1-2: new low speed USB device using uhci_hcd and address 2 ieee1394: Host added: ID:BUS[0-01:1023] GUID[00023c00210933ca] lp: driver loaded but no devices found NET: Registered protocol family 10 lo: Disabled Privacy Extensions IPv6 over IPv4 tunneling driver agpgart: Found an AGP 2.0 compliant device at 0000:00:00.0. agpgart: Putting AGP V2 device at 0000:00:00.0 into 4x mode agpgart: Putting AGP V2 device at 0000:01:00.0 into 4x mode usb 1-2: configuration #1 chosen from 1 choice ivtv0-osd warning: ivtvfb_check_var ivtv0-osd warning: ivtvfb_check_var ivtv0-osd warning: ivtvfb_set_par __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com _______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
