Darko Gavrilovic wrote: > Hello, I just recently upgraded to MythDora 4.0 from a Myth + FC6 setup. > The setup works great except that I can't get the video & sound to > properly behave. > > I searched and can't seem to find a similar problem. > > I have X displaying/redirected to an NTSC TV through the PVR-350 video & > audio outs. > > In MythTV, if I set "use PVR-350 out..." I get no video -- just audio > display. > > If I don't select "use PVR-350 outs" on only get video but no sound/audio. > > Does anyone else have a similar problem?
Hello, an update to my earlier post. I noticed that the m/b has a built in sound card. I tried plugging in a cable and going into the TV and sound is coming out of it. So I can get audio through the sound card bit I can't get the audio and video at the same time through the pvr350. Any help would be appreciated. dg ivtv: ==================== START INIT IVTV ==================== ivtv: version 0.10.2 (tagged release) loading ivtv: Linux version: 2.6.20-1.2948.fc6 SMP mod_unload 686 4KSTACKS ivtv: In case of problems please include the debug info between ivtv: the START INIT IVTV and END INIT IVTV lines, along with ivtv: any module options, when mailing the ivtv-users mailinglist. ivtv0: Autodetected Hauppauge card (cx23415 based) ACPI: PCI Interrupt 0000:01:08.0[A] -> GSI 17 (level, low) -> IRQ 20 ivtv0: loaded v4l-cx2341x-enc.fw firmware (376836 bytes) ivtv0: loaded v4l-cx2341x-dec.fw firmware (262144 bytes) ivtv0: Encoder revision: 0x02060039 ivtv0: Decoder revision: 0x02020023 tveeprom 1-0050: Hauppauge model 48132, rev K268, serial# 9921495 tveeprom 1-0050: tuner model is LG TAPE H001F MK3 (idx 68, type 47) tveeprom 1-0050: TV standards NTSC(M) (eeprom 0x08) tveeprom 1-0050: audio processor is MSP4448 (idx 27) tveeprom 1-0050: decoder processor is SAA7115 (idx 19) tveeprom 1-0050: has radio, has IR receiver, has no IR transmitter ivtv0: Autodetected Hauppauge WinTV PVR-350 tuner 1-0043: chip found @ 0x86 (ivtv i2c driver #0) tda9887 1-0043: tda988[5/6/7] found @ 0x43 (tuner) tuner 1-0061: chip found @ 0xc2 (ivtv i2c driver #0) saa7115 1-0021: saa7115 found (1f7115d0e100000) @ 0x42 (ivtv i2c driver #0) saa7127 1-0044: saa7129 found @ 0x88 (ivtv i2c driver #0) msp3400 1-0040: MSP4448G-A2 found @ 0x80 (ivtv i2c driver #0) msp3400 1-0040: MSP4448G-A2 supports radio, mode is autodetect and autoselect ivtv0: Registered device video0 for encoder MPEG (4 MB) ivtv0: Registered device video32 for encoder YUV (2 MB) ivtv0: Registered device vbi0 for encoder VBI (1 MB) ivtv0: Registered device video24 for encoder PCM audio (1 MB) ivtv0: Registered device radio0 for encoder radio ivtv0: Registered device video16 for decoder MPEG (1 MB) ivtv0: Registered device vbi8 for decoder VBI (1 MB) ivtv0: Registered device vbi16 for decoder VOUT ivtv0: Registered device video48 for decoder YUV (1 MB) ivtv0: loaded v4l-cx2341x-init.mpg firmware (155648 bytes) tuner 1-0061: type set to 47 (LG NTSC (TAPE series)) ivtv0: Initialized Hauppauge WinTV PVR-350, card #0 ACPI: PCI Interrupt 0000:00:1f.5[B] -> GSI 17 (level, low) -> IRQ 20 PCI: Setting latency timer of device 0000:00:1f.5 to 64 ivtv: ==================== END INIT IVTV ==================== _______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
