Hi,

I have a problem when attempting to receive two French analogue channels 
through the Hauppauge PVR 150.  For these two channels, the video is fine but 
there is no sound.  When I tune to other channels, I get both the video and 
audio ok.  As I understand, all channels are in SECAM L format.

When running 'ivtvctl -d /dev/video2 --log-status' I noticed that the two 
problem channels had one thing in common.  This is that the detected audio 
standard is A2-DK1 (See below):

LOG-STATUS

ivtv0: =================  START STATUS CARD #0  =================
   tveeprom 1-0050: The eeprom says no radio is present, but the tuner type
   tveeprom 1-0050: indicates otherwise. I will assume that radio is present.
   tveeprom 1-0050: Hauppauge model 26139, rev F1A5, serial# 10162082
   tveeprom 1-0050: tuner model is TCL MPE05-2 (idx 105, type 38)
   tveeprom 1-0050: TV standards PAL(B/G) PAL(I) SECAM(L/L') PAL(D/D1/K) 
(eeprom 0x74)
   tveeprom 1-0050: audio processor is CX25842 (idx 36)
   tveeprom 1-0050: decoder processor is CX25842 (idx 29)
   tveeprom 1-0050: has radio, has IR remote
   tuner 1-0061: Tuner mode:      analog TV
   tuner 1-0061: Frequency:       759.25 MHz
   tuner 1-0061: Standard:        0x007f0000
   tda9887 1-0043: Data bytes: b=0x04 c=0x10 e=0x49
   cx25840 1-0044: Video signal:              present
   cx25840 1-0044: Detected format:           SECAM
   cx25840 1-0044: Detected audio mode:       mono
   cx25840 1-0044: Detected audio standard:   A2-DK1
   cx25840 1-0044: Audio muted:               no
   cx25840 1-0044: Audio microcontroller:     running
   cx25840 1-0044: Configured audio standard: automatic detection
   cx25840 1-0044: Configured audio system:   automatic standard and mode 
detection
   cx25840 1-0044: Specified standard:        SECAM
   cx25840 1-0044: Specified video input:     Composite 7
   cx25840 1-0044: Specified audio input:     Tuner (In8)
   cx25840 1-0044: Specified audioclock freq: 48000 Hz
   cx25840 1-0044: Preferred audio mode:      stereo
   cx25840 1-0044: Selected 65 MHz format:    autodetect
   cx25840 1-0044: Selected 45 MHz format:    chroma
   wm8775 1-001b: Input: 2
   ivtv0: ==================  END STATUS CARD #0  ==================


For the remaining channels that had the audio working ok, the detected audio 
standard is AM-L.  Could there be a problem with configuring the audio standard 
to match the detected audio standard of A2-DK1?


My ivtv version is 0.7.1, operating system is Linux fedora core 5, kernel 
version is 2.6.17-1.2174_FC5smp.  I've attached the INIT IVTV information.

Any help / suggested solutions would be greatly appreciated.

Steve

May 13 05:04:46 VDW-DHP-IPTV1 kernel: ivtv:  ==================== START INIT 
IVTV ====================
May 13 05:04:46 VDW-DHP-IPTV1 kernel: ivtv:  version 0.7.1 (tagged release) 
loading
May 13 05:04:46 VDW-DHP-IPTV1 kernel: ivtv:  Linux version: 
2.6.17-1.2174_FC5smp SMP mod_unload 686 REGPARM 4KSTACKS gcc-4.1
May 13 05:04:46 VDW-DHP-IPTV1 kernel: ivtv:  In case of problems please include 
the debug info between
May 13 05:04:46 VDW-DHP-IPTV1 kernel: ivtv:  the START INIT IVTV and END INIT 
IVTV lines, along with
May 13 05:04:46 VDW-DHP-IPTV1 kernel: ivtv:  any module options, when mailing 
the ivtv-users mailinglist.
May 13 05:04:46 VDW-DHP-IPTV1 kernel: ivtv0: Autodetected Hauppauge WinTV 
PVR-150 card (cx23416 based)
May 13 05:04:46 VDW-DHP-IPTV1 kernel: ACPI: PCI Interrupt 0000:03:02.0[A] -> 
GSI 24 (level, low) -> IRQ 217
May 13 05:04:46 VDW-DHP-IPTV1 kernel: ivtv0: Unreasonably low latency timer, 
setting to 64 (was 32)
May 13 05:04:46 VDW-DHP-IPTV1 kernel: tveeprom 1-0050: The eeprom says no radio 
is present, but the tuner type
May 13 05:04:46 VDW-DHP-IPTV1 kernel: tveeprom 1-0050: indicates otherwise. I 
will assume that radio is present.
May 13 05:04:46 VDW-DHP-IPTV1 kernel: tveeprom 1-0050: Hauppauge model 26139, 
rev F1A5, serial# 10162082
May 13 05:04:46 VDW-DHP-IPTV1 kernel: tveeprom 1-0050: tuner model is TCL 
MPE05-2 (idx 105, type 38)
May 13 05:04:46 VDW-DHP-IPTV1 kernel: tveeprom 1-0050: TV standards PAL(B/G) 
PAL(I) SECAM(L/L') PAL(D/D1/K) (eeprom 0x74)
May 13 05:04:46 VDW-DHP-IPTV1 kernel: tveeprom 1-0050: audio processor is 
CX25842 (idx 36)
May 13 05:04:46 VDW-DHP-IPTV1 kernel: tveeprom 1-0050: decoder processor is 
CX25842 (idx 29)
May 13 05:04:46 VDW-DHP-IPTV1 kernel: tveeprom 1-0050: has radio, has IR remote
May 13 05:04:46 VDW-DHP-IPTV1 kernel: cx2388x v4l2 driver version 0.0.5 loaded
May 13 05:04:46 VDW-DHP-IPTV1 kernel: cx2388x alsa driver version 0.0.5 loaded
May 13 05:04:46 VDW-DHP-IPTV1 kernel: cx2388x dvb driver version 0.0.5 loaded
May 13 05:04:46 VDW-DHP-IPTV1 kernel: tuner 1-0061: chip found @ 0xc2 (ivtv i2c 
driver #0)
May 13 05:04:46 VDW-DHP-IPTV1 kernel: cx88_blackbird: Unknown symbol 
cx88_do_ioctl
May 13 05:04:46 VDW-DHP-IPTV1 kernel: cx88_blackbird: Unknown symbol 
cx88_do_ioctl
May 13 05:04:46 VDW-DHP-IPTV1 kernel: saa7146: register extension 'budget_ci 
dvb'.
May 13 05:04:46 VDW-DHP-IPTV1 kernel: tda9887 1-0043: chip found @ 0x86 (ivtv 
i2c driver #0)
May 13 05:04:46 VDW-DHP-IPTV1 kernel: cx25840 1-0044: cx25842-23 found @ 0x88 
(ivtv i2c driver #0)
May 13 05:04:46 VDW-DHP-IPTV1 kernel: cx25840 1-0044: loaded v4l-cx25840.fw 
firmware (16382 bytes)
May 13 05:04:46 VDW-DHP-IPTV1 kernel: wm8775 1-001b: chip found @ 0x36 (ivtv 
i2c driver #0)
May 13 05:04:46 VDW-DHP-IPTV1 kernel: ivtv0: loaded v4l-cx2341x-enc.fw firmware 
(262144 bytes)
May 13 05:04:46 VDW-DHP-IPTV1 kernel: ivtv0: Encoder revision: 0x02050032
May 13 05:04:46 VDW-DHP-IPTV1 kernel: ivtv0: Allocate DMA encoder MPEG stream: 
128 x 32768 buffers (4096KB total)
May 13 05:04:46 VDW-DHP-IPTV1 kernel: ivtv0: Allocate DMA encoder YUV stream: 
161 x 12960 buffers (2048KB total)
May 13 05:04:46 VDW-DHP-IPTV1 kernel: ivtv0: Allocate DMA encoder VBI stream: 
80 x 26208 buffers (2048KB total)
May 13 05:04:46 VDW-DHP-IPTV1 kernel: ivtv0: Allocate DMA encoder PCM audio 
stream: 455 x 4608 buffers (2048KB total)
May 13 05:04:46 VDW-DHP-IPTV1 kernel: ivtv0: Create encoder radio stream
May 13 05:04:46 VDW-DHP-IPTV1 kernel: tuner 1-0061: type set to 38 (Philips 
PAL/SECAM multi (FM1216ME MK3))
May 13 05:04:46 VDW-DHP-IPTV1 kernel: ivtv0: Initialized Hauppauge WinTV 
PVR-150, card #0
May 13 05:04:46 VDW-DHP-IPTV1 kernel: ACPI: PCI Interrupt 0000:03:01.0[A] -> 
<6>ivtv:  ====================  END INIT IVTV  ====================
_______________________________________________
ivtv-users mailing list
[email protected]
http://ivtvdriver.org/mailman/listinfo/ivtv-users

Reply via email to