Hi ivtv dev,
I have two PVR250 cards and problem with recognizing tuner type.
IVTV is 0.10.1 under KnoppMyth R5F1.
Here are IVTV & LSPCI logs:
[EMAIL PROTECTED]:/home/mythtv# dmesg | tac | sed -n '/=\ \ END INIT IVTV\ \
=/,/= START INIT IVTV =/p; /= START INIT IVTV =/q' | tac
ivtv: ==================== START INIT IVTV ====================
ivtv: version 0.10.1 (tagged release) loading
ivtv: Linux version: 2.6.18-chw-13 SMP preempt mod_unload 586 gcc-4.1
ivtv: In case of problems please include the debug info between
ivtv: the START INIT IVTV and END INIT IVTV lines, along with
ivtv: any module options, when mailing the ivtv-users mailinglist.
ACPI: PCI Interrupt Link [APC4] enabled at IRQ 19
ACPI: PCI Interrupt 0000:03:06.0[A] -> Link [APC4] -> GSI 19 (level,
low) -> IRQ 19
ohci1394: fw-host0: OHCI-1394 1.1 (PCI): IRQ=[19]
MMIO=[fddff000-fddff7ff] Max Packet=[2048] IR/IT contexts=[4/8]
ACPI: PCI Interrupt Link [APCJ] enabled at IRQ 20
ACPI: PCI Interrupt 0000:00:10.2[C] -> Link [APCJ] -> GSI 20 (level,
low) -> IRQ 20
PCI: Setting latency timer of device 0000:00:10.2 to 64
intel8x0_measure_ac97_clock: measured 50655 usecs
intel8x0: clocking to 46909
ivtv0: Autodetected Hauppauge card (cx23416 based)
ACPI: PCI Interrupt Link [APC1] enabled at IRQ 16
ACPI: PCI Interrupt 0000:03:07.0[A] -> Link [APC1] -> GSI 16 (level,
low) -> IRQ 21
ivtv0: Unreasonably low latency timer, setting to 64 (was 32)
ivtv0: loaded v4l-cx2341x-enc.fw firmware (376836 bytes)
ivtv0: Encoder revision: 0x02060039
tuner 2-0043: chip found @ 0x86 (ivtv i2c driver #0)
tda9887 2-0043: tda988[5/6/7] found @ 0x43 (tuner)
tuner 2-0061: chip found @ 0xc2 (ivtv i2c driver #0)
ieee1394: Host added: ID:BUS[0-00:1023] GUID[00016c20000f178c]
eth1394: eth1: IEEE-1394 IPv4 over 1394 Ethernet (fw-host0)
msp3400 2-0040: MSP4418G-B3 found @ 0x80 (ivtv i2c driver #0)
msp3400 2-0040: MSP4418G-B3 supports nicam and radio, mode is autodetect
and autoselect
saa7115 2-0021: saa7115 found (1f7115d0e100000) @ 0x42 (ivtv i2c driver #0)
tveeprom 2-0050: Hauppauge model 32599, rev D180, serial# 7854617
tveeprom 2-0050: tuner model is Philips FQ1216LME MK3 (idx 80, type 4)
tveeprom 2-0050: TV standards PAL(B/G) PAL(I) SECAM(L/L') PAL(D/D1/K)
(eeprom 0x74)
tveeprom 2-0050: audio processor is MSP4418 (idx 25)
tveeprom 2-0050: decoder processor is SAA7115 (idx 19)
tveeprom 2-0050: has no radio, has no IR receiver, has no IR transmitter
ivtv0: Autodetected Hauppauge WinTV PVR-250
ivtv0: tveeprom cannot autodetect tuner!<6>ivtv0: Registered device
video0 for encoder MPEG (4 MB)
ivtv0: Registered device video32 for encoder YUV (2 MB)
ivtv0: Registered device vbi0 for encoder VBI (1 MB)
ivtv0: Registered device video24 for encoder PCM audio (1 MB)
tuner 2-0061: tuner type not set
tuner 2-0061: tuner type not set
ivtv0: Initialized Hauppauge WinTV PVR-250, card #0
ivtv: ====================== NEXT CARD ======================
ivtv1: Autodetected Hauppauge card (cx23416 based)
ACPI: PCI Interrupt Link [APC3] enabled at IRQ 18
ACPI: PCI Interrupt 0000:03:09.0[A] -> Link [APC3] -> GSI 18 (level,
low) -> IRQ 22
ivtv1: Unreasonably low latency timer, setting to 64 (was 32)
ivtv1: loaded v4l-cx2341x-enc.fw firmware (376836 bytes)
ivtv1: Encoder revision: 0x02060039
tuner 3-0043: chip found @ 0x86 (ivtv i2c driver #1)
tda9887 3-0043: tda988[5/6/7] found @ 0x43 (tuner)
tuner 3-0061: chip found @ 0xc2 (ivtv i2c driver #1)
msp3400 3-0040: MSP4418G-B3 found @ 0x80 (ivtv i2c driver #1)
msp3400 3-0040: MSP4418G-B3 supports nicam and radio, mode is autodetect
and autoselect
saa7115 3-0021: saa7115 found (1f7115d0e100000) @ 0x42 (ivtv i2c driver #1)
tveeprom 3-0050: Hauppauge model 32599, rev D180, serial# 7854802
tveeprom 3-0050: tuner model is Philips FQ1216LME MK3 (idx 80, type 4)
tveeprom 3-0050: TV standards PAL(B/G) PAL(I) SECAM(L/L') PAL(D/D1/K)
(eeprom 0x74)
tveeprom 3-0050: audio processor is MSP4418 (idx 25)
tveeprom 3-0050: decoder processor is SAA7115 (idx 19)
tveeprom 3-0050: has no radio, has no IR receiver, has no IR transmitter
ivtv1: Autodetected Hauppauge WinTV PVR-250
ivtv1: tveeprom cannot autodetect tuner!<6>ivtv1: Registered device
video1 for encoder MPEG (4 MB)
ivtv1: Registered device video33 for encoder YUV (2 MB)
ivtv1: Registered device vbi1 for encoder VBI (1 MB)
ivtv1: Registered device video25 for encoder PCM audio (1 MB)
tuner 3-0061: tuner type not set
tuner 3-0061: tuner type not set
ivtv1: Initialized Hauppauge WinTV PVR-250, card #1
ivtv: ==================== END INIT IVTV ====================
lspci gives:
03:07.0 Multimedia video controller: Internext Compression Inc iTVC16
(CX23416) MPEG-2 Encoder (rev 01)
Subsystem: Hauppauge computer works Inc. WinTV PVR 250
Flags: bus master, medium devsel, latency 64, IRQ 21
Memory at dc000000 (32-bit, prefetchable) [size=64M]
Capabilities: [44] Power Management version 2
03:09.0 Multimedia video controller: Internext Compression Inc iTVC16
(CX23416) MPEG-2 Encoder (rev 01)
Subsystem: Hauppauge computer works Inc. WinTV PVR 250
Flags: bus master, medium devsel, latency 64, IRQ 22
Memory at d8000000 (32-bit, prefetchable) [size=64M]
Capabilities: [44] Power Management version 2
Hope it helps with resolving my problem.
thx in advance
begin:vcard
fn:Warpme
n:;Warpme
email;internet:[EMAIL PROTECTED]
version:2.1
end:vcard
_______________________________________________
ivtv-users mailing list
[email protected]
http://ivtvdriver.org/mailman/listinfo/ivtv-users
