After upgrading to Ubuntu Feisty 7.04, I am having problems with my X Server crashing when using the ivtv-fb with my PVR-350. I am using IVTV version 0.10.1, Kernel 2.6.20-14, MythTV version 0.20.20060828-3.
The X server will crash every time under MythWeb, and when I go into (and exit out of) MythTV->Settings->Appearance. I don't see the problem if I reconfigure xorg.conf to use a regualer vga monitor instead of my PVR-350 TV output. I don't believe this is a hardware issue, since (on the same machine) I have an older MythTV installation running on Fedora Core 4 that works just fine (at least it doesn't crash my X server). Here is output from dmesg: [ 42.647998] ivtv: ==================== START INIT IVTV ==================== [ 42.648003] ivtv: version 0.10.1 (tagged release) loading [ 42.648005] ivtv: Linux version: 2.6.20-16-generic SMP mod_unload 586 [ 42.648007] ivtv: In case of problems please include the debug info between [ 42.648010] ivtv: the START INIT IVTV and END INIT IVTV lines, along with [ 42.648012] ivtv: any module options, when mailing the ivtv-users mailinglist. [ 42.648109] ivtv0: Autodetected Hauppauge card (cx23415 based) [ 42.781988] ACPI: PCI Interrupt 0000:02:0c.0[A] -> GSI 20 (level, low) -> IRQ 19 [ 42.907820] input: PC Speaker as /class/input/input2 [ 42.915429] usbcore: registered new interface driver pvrusb2 [ 42.915434] drivers/media/video/pvrusb2/pvrusb2-main.c: Hauppauge WinTV-PVR-USB2 MPEG2 Encoder/Tuner : V4L in-tree version [ 42.915438] drivers/media/video/pvrusb2/pvrusb2-main.c: Debug mask is 15 (0xf) [ 43.015560] parport: PnPBIOS parport detected. [ 43.015673] parport0: PC-style at 0x378 (0x778), irq 7, dma 3 [PCSPP,TRISTATE,COMPAT,EPP,ECP,DMA] [ 43.022492] logips2pp: Detected unknown logitech mouse model 1 [ 43.026188] usb 5-2: reset high speed USB device using ehci_hcd and address 2 [ 43.504097] input: PS/2 Logitech Mouse as /class/input/input3 [ 43.602085] ivtv0: loaded v4l-cx2341x-enc.fw firmware (376836 bytes) [ 43.646770] ivtv0: loaded v4l-cx2341x-dec.fw firmware (262144 bytes) [ 43.868518] ivtv0: Encoder revision: 0x02060039 [ 43.876519] ivtv0: Decoder revision: 0x02020023 [ 43.956460] msp3400 0-0040: MSP4448G-A2 found @ 0x80 (pvrusb2_a) [ 43.956464] msp3400 0-0040: MSP4448G-A2 supports radio, mode is autodetect and autoselect [ 44.019073] saa7115 0-0021: saa7115 found (1f7115d0e100000) @ 0x42 (pvrusb2_a) [ 44.223762] tuner 0-0061: chip found @ 0xc2 (pvrusb2_a) [ 44.243809] msp3400 1-0040: MSP4448G-A2 found @ 0x80 (ivtv i2c driver #0) [ 44.243817] msp3400 1-0040: MSP4448G-A2 supports radio, mode is autodetect and autoselect [ 44.252624] i2c_adapter i2c-1: Client creation failed at 0x44 (-1) [ 44.258783] tveeprom 0-0050: Hauppauge model 29022, rev C333, serial# 6523969 [ 44.258786] tveeprom 0-0050: tuner model is Temic 4039FR5 (idx 33, type 21) [ 44.258789] tveeprom 0-0050: TV standards NTSC(M) (eeprom 0x08) [ 44.258792] tveeprom 0-0050: audio processor is MSP4448 (idx 27) [ 44.258795] tveeprom 0-0050: decoder processor is SAA7115 (idx 19) [ 44.258797] tveeprom 0-0050: has radio, has IR receiver, has no IR transmitter [ 44.289520] saa7115 1-0021: saa7115 found (1f7115d0e100000) @ 0x42 (ivtv i2c driver #0) [ 44.293212] tuner 0-0061: type set to 21 (Temic NTSC (4039 FR5)) [ 44.398934] msp3400 0-0040: MSP4448G-A2 rev1 = 0x0117 rev2 = 0x3042 [ 44.398937] msp3400 0-0040: Audio: volume 65535 [ 44.398941] msp3400 0-0040: Standard: autodetect start (mono) [ 44.398943] msp3400 0-0040: Audmode: 0x0001 [ 44.398945] msp3400 0-0040: Routing: 0x00000000 (input) 0x00000044 (output) [ 44.398948] msp3400 0-0040: ACB: 0x0c00 [ 44.398951] saa7115 0-0021: Audio frequency: 48000 Hz [ 44.400948] saa7115 0-0021: Input: Composite 4 [ 44.400950] saa7115 0-0021: Video signal: bad [ 44.400952] saa7115 0-0021: Frequency: 60 Hz [ 44.400954] saa7115 0-0021: Detected format: NTSC [ 44.400956] saa7115 0-0021: Width, Height: 720, 480 [ 44.400960] tuner 0-0061: Tuner mode: analog TV [ 44.400962] tuner 0-0061: Frequency: 175.25 MHz [ 44.400971] tuner 0-0061: Standard: 0x00000100 [ 44.400975] pvrusb2: Device initialization completed successfully. [ 44.401000] pvrusb2: registered device video0 [mpeg] [ 44.478500] tuner 1-0043: chip found @ 0x86 (ivtv i2c driver #0) [ 44.478538] tda9887 1-0043: tda988[5/6/7] found @ 0x43 (tuner) [ 44.483074] tuner 1-0061: chip found @ 0xc2 (ivtv i2c driver #0) [ 44.572857] tveeprom 1-0050: Hauppauge model 48132, rev K268, serial# 2918449 [ 44.572862] tveeprom 1-0050: tuner model is LG TAPE H001F MK3 (idx 68, type 47) [ 44.572865] tveeprom 1-0050: TV standards NTSC(M) (eeprom 0x08) [ 44.572868] tveeprom 1-0050: audio processor is MSP4448 (idx 27) [ 44.572871] tveeprom 1-0050: decoder processor is SAA7115 (idx 19) [ 44.572873] tveeprom 1-0050: has radio, has IR receiver, has no IR transmitter [ 44.572877] ivtv0: Autodetected Hauppauge WinTV PVR-350 [ 44.655558] saa7127 1-0044: saa7129 found @ 0x88 (ivtv i2c driver #0) [ 44.670133] ivtv0: Registered device video1 for encoder MPEG (4 MB) [ 44.670370] ivtv0: Registered device video32 for encoder YUV (2 MB) [ 44.670648] ivtv0: Registered device vbi0 for encoder VBI (1 MB) [ 44.670763] ivtv0: Registered device video24 for encoder PCM audio (1 MB) [ 44.671126] ivtv0: Registered device radio0 for encoder radio [ 44.671162] ivtv0: Registered device video16 for decoder MPEG (1 MB) [ 44.671231] ivtv0: Registered device vbi8 for decoder VBI (1 MB) [ 44.671725] ivtv0: Registered device vbi16 for decoder VOUT [ 44.671787] ivtv0: Registered device video48 for decoder YUV (1 MB) [ 44.726952] ivtv0: loaded v4l-cx2341x-init.mpg firmware (155648 bytes) [ 44.834656] tuner 1-0061: type set to 47 (LG NTSC (TAPE series)) [ 45.251119] ivtv0: Initialized Hauppauge WinTV PVR-350, card #0 [ 45.251140] ivtv: ==================== END INIT IVTV ==================== I can't find anything else in the log files. Anyone know what could be going on here? -Thanks in advance. _______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
