I've got a PVR-350 and after its been running a while, but always in the 
afternoon, not the morning, it starts showing rectangular blocks of rubbish 
in the video stream.
We've looked at the aerial, the signal amplifier and the rest of the input. No 
troubles there with an alternate card at the same time.
It is midsummer here, and that means HOT, but the house if not overhot. 
Restarting the computer seems to be the only way to reset the card and it then 
immediately is fine.
Can users suggest any other things to look at?
if someone needs a screenshot, I'll to to sort one out


dmesg
ivtv:  ==================== START INIT IVTV ====================
ivtv:  version 1.0.0 (2.6.22-1-mepis-smp SMP preempt mod_unload 686 ) loading
ivtv0: Autodetected Hauppauge card (cx23415 based)
ACPI: PCI Interrupt 0000:02:09.0[A] -> GSI 17 (level, low) -> IRQ 20
usb 5-2: configuration #1 chosen from 1 choice
usbcore: registered new interface driver hiddev
input: Logitech USB Receiver as /class/input/input2
input: USB HID v1.10 Keyboard [Logitech USB Receiver] on usb-0000:00:1d.0-1
drivers/hid/usbhid/hid-core.c: Fixing up Logitech keyboard report descriptor
input: Logitech USB Receiver as /class/input/input3
input,hiddev96: USB HID v1.10 Mouse [Logitech USB Receiver] on 
usb-0000:00:1d.0-1
input: HID 13ec:000f as /class/input/input4
input: USB HID v1.10 Keyboard [HID 13ec:000f] on usb-0000:00:1d.3-2
usbcore: registered new interface driver usbhid
drivers/hid/usbhid/hid-core.c: v2.6:USB HID core driver
ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes)
ivtv0: loaded v4l-cx2341x-dec.fw firmware (262144 bytes)
ivtv0: Encoder revision: 0x02040011
ivtv0: Recommended firmware version is 0x02060039.
ivtv0: Decoder revision: 0x02020023
tveeprom 1-0050: Hauppauge model 48139, rev K257, serial# 8577521
tveeprom 1-0050: tuner model is Philips FM1216 ME MK3 (idx 57, type 38)
tveeprom 1-0050: TV standards PAL(B/G) PAL(I) SECAM(L/L') PAL(D/D1/K) (eeprom 
0x74)
tveeprom 1-0050: audio processor is MSP4418 (idx 25)
tveeprom 1-0050: decoder processor is SAA7115 (idx 19)
tveeprom 1-0050: has radio, has IR receiver, has no IR transmitter
ivtv0: Autodetected Hauppauge WinTV PVR-350
tuner 1-0043: chip found @ 0x86 (ivtv i2c driver #0)
tda9887 1-0043: tda988[5/6/7] found @ 0x43 (tuner)
tuner 1-0061: chip found @ 0xc2 (ivtv i2c driver #0)
saa7115 1-0021: saa7115 found (1f7115d0e100000) @ 0x42 (ivtv i2c driver #0)
saa7127 1-0044: saa7129 found @ 0x88 (ivtv i2c driver #0)
usb-storage: device scan complete
usb-storage: device scan complete
msp3400 1-0040: MSP4418G-B3 found @ 0x80 (ivtv i2c driver #0)
msp3400 1-0040: MSP4418G-B3 supports nicam and radio, mode is autodetect and 
autoselect
tuner 1-0061: type set to 38 (Philips PAL/SECAM multi (FM1216ME MK3))
scsi 5:0:0:0: Direct-Access     ASUS     READER30     -CF 1.00 PQ: 0 ANSI: 0 
CCS
scsi 4:0:0:0: Direct-Access     Maxtor   3200             0344 PQ: 0 ANSI: 4
scsi 5:0:0:1: Direct-Access     ASUS     READER30     -SM 1.00 PQ: 0 ANSI: 0 
CCS
scsi 5:0:0:2: Direct-Access     ASUS     READER30     -SD 1.00 PQ: 0 ANSI: 0 
CCS
scsi 5:0:0:3: Direct-Access     ASUS     READER30     -MS 1.00 PQ: 0 ANSI: 0 
CCS
sd 5:0:0:0: [sdb] Attached SCSI removable disk
sd 5:0:0:0: Attached scsi generic sg2 type 0
sd 5:0:0:1: [sdc] Attached SCSI removable disk
sd 5:0:0:1: Attached scsi generic sg3 type 0
sd 5:0:0:2: [sdd] Attached SCSI removable disk
sd 5:0:0:2: Attached scsi generic sg4 type 0
sd 5:0:0:3: [sde] Attached SCSI removable disk
sd 5:0:0:3: Attached scsi generic sg5 type 0
sd 4:0:0:0: [sdf] 625142448 512-byte hardware sectors (320073 MB)
sd 4:0:0:0: [sdf] Write Protect is off
sd 4:0:0:0: [sdf] Mode Sense: 17 00 00 00
sd 4:0:0:0: [sdf] Assuming drive cache: write through
sd 4:0:0:0: [sdf] 625142448 512-byte hardware sectors (320073 MB)
sd 4:0:0:0: [sdf] Write Protect is off
sd 4:0:0:0: [sdf] Mode Sense: 17 00 00 00
sd 4:0:0:0: [sdf] Assuming drive cache: write through
 sdf: sdf1
sd 4:0:0:0: [sdf] Attached SCSI disk
sd 4:0:0:0: Attached scsi generic sg6 type 0
ivtv0: Registered device video0 for encoder MPEG (4 MB)
ivtv0: Registered device video32 for encoder YUV (2 MB)
ivtv0: Registered device vbi0 for encoder VBI (1 MB)
ivtv0: Registered device video24 for encoder PCM audio (1 MB)
ivtv0: Registered device radio0 for encoder radio
ivtv0: Registered device video16 for decoder MPEG (1 MB)
ivtv0: Registered device vbi8 for decoder VBI (1 MB)
ivtv0: Registered device vbi16 for decoder VOUT
ivtv0: Registered device video48 for decoder YUV (1 MB)
ivtv0: loaded v4l-cx2341x-init.mpg firmware (155648 bytes)
ivtv0: Initialized Hauppauge WinTV PVR-350, card #0
ivtv:  ====================  END INIT IVTV  ====================



-- 
I owe, I owe,
It's off to work I go...

_______________________________________________
ivtv-users mailing list
[email protected]
http://ivtvdriver.org/mailman/listinfo/ivtv-users

Reply via email to