Marko Doda schreef op 1-1-2003 2:58: > i forgot to send the dmesg output gives (with no parametars, only modprobe > ivtv) > > ivtv: Start initialization, version 1.1.0 > ivtv0: Initializing card #0 > ivtv0: pal= argument not recognised > ivtv0: Autodetected Hauppauge card (cx23416 based) > ACPI: PCI Interrupt 0000:00:06.0[A] -> GSI 17 (level, low) -> IRQ 20 > tuner 0-0043: chip found @ 0x86 (ivtv i2c driver #0) > tda9887 0-0043: tda988[5/6/7] found @ 0x43 (tuner) > tuner 0-0043: type set to tda9887 > tuner 0-0061: chip found @ 0xc2 (ivtv i2c driver #0) > cx25840 0-0044: cx25843-24 found @ 0x88 (ivtv i2c driver #0) > wm8775 0-001b: chip found @ 0x36 (ivtv i2c driver #0) > tveeprom 0-0050: Encountered bad packet header [ff]. Corrupt or not a > Hauppauge eeprom. > ivtv0: Invalid EEPROM > ivtv0: Registered device video0 for encoder MPG (4096 kB) > ivtv0: Registered device video32 for encoder YUV (2048 kB) > ivtv0: Registered device vbi0 for encoder VBI (1024 kB) > ivtv0: Registered device video24 for encoder PCM (320 kB) > ivtv0: Registered device radio0 for encoder radio > ivtv0: Initialized card #0: Hauppauge WinTV PVR-150 > ivtv: End initialization > > i have also tried on kubuntu 7.04 and it didn't work there too >
modinfo ivtv might give you the option you need... modprobe ivtv pal (b,g,h,d,k,.....) should give you the result you're looking for. Your dmesg-output gives an error about an eeprom not correctly loaded, might wanna check that out. After: ivtv0: Autodetected Hauppauge card (cx23416 based) my system continues loading firmware, you have that installed? Regards, Jos Hoekstra _______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
