On Wed, Nov 26, 2008 at 3:03 PM, igloocentral hotmail < [EMAIL PROTECTED]> wrote:
> > > Has anyone managed to get the ir blaster working with the hvr-1600? > > lirc_pvr150 works fine with the HVR-1600. I had it blasting no problem. > However, it supports a limited number of set-top boxes. Check first if your > codeset is supported, otherwise you'll need a blaster that supports the full > set of codes, like the MCE remote. Good luck. > > http://www.blushingpenguin.com/mark/lmilk/IRcodesets.html > http://members.shaw.ca/paulsid/pages/knoppmyth+hvr-1600+asus-m3a.html > http://www.blushingpenguin.com/mark/blog/?p=24 > Thanks this was helpful, I finally found some time yesterday to tinker. Just a few obstacles, I had to remove the references and calls to ivtv_reset_ir_gpio() otherwise it would not load. The LED is not entirely efficient either, if I have the LED off by a mm on the STB it would not work at all. Considering replacing the emitter with and IR LED. Thanks for the lead... Al
_______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
