Andy Walls wrote:
On Mon, 2009-04-13 at 08:02 -0600, Ronal B Morse wrote:
Booting straight to Linux from a power off state results in a black
screen and no audio from both players. ivti-tune and v4l2-ctl
set--frequency both produce normal output and indicate the card has been
set to the proper channel/frequency (3/61.125)
It seems that Ubuntu isn't initializing something on startup, but once
whatever it is gets set it persists through a warm reboot.
As a follow-up I've determined that the sequence of commands:
sudo modprobe -r cx18
sudo modprobe cx18
will enable the card, after which it will perform normally until the
machine is powered off. Should this be necessary?
In a perfect world no. A very busy PCI bus while the module is setting
up the chip registers and doing a firmware load can cause PCI bus errors
though. At boot-up, a high load on PCI bus in more recent kernels is
not uncommon.
I have some debugging code from 3 weeks ago at this repo:
http://linuxtv.org/hg/~awalls/cx18-init-debug/
http://linuxtv.org/hg/~awalls/cx18-init-debug/archive/tip.tar.gz
to get more insight into what may be going wrong and to also verify the
digitizer firmware load.
If you could use the driver from this repository and, IIRC, add an
options cx18 debug=15
to /etc/modprobe.conf, that will let me see if PCI MMIO writes are
failing as the module is being loaded at boot up. It will also tell me
if the digitizer firmware is getting loaded properly.
Regards,
Andy
_______________________________________________
ivtv-users mailing list
[email protected]
http://ivtvdriver.org/mailman/listinfo/ivtv-users
Will do. Thanks.
Quick question: I'm running a 64-bit version of the O/S. Does that
matter?
Ron Morse
|
_______________________________________________
ivtv-users mailing list
[email protected]
http://ivtvdriver.org/mailman/listinfo/ivtv-users
