Oh sorry, I thought you are just searching for a software to watch TV. Did not read the entire dmesg output.
2011/3/3 Andy Walls <[email protected]> > Alex <[email protected]> wrote: > > >Hi. > > > >I´m using Debian 6.0 on my Vaio and want to watch tv under linux but > >nothing happens. I installed the ivtv-firmware and dev/video0 is > >created. But when i use "zapping" to watch tv and look for tv-channels > >nothing is found. > > > >the command "lspci -v" prints the following: > > > >01:00.0 VGA compatible controller: nVidia Corporation NV36 [GeForce FX > >Go5700] (rev a1) (prog-if 00 [VGA controller]) > >Subsystem: Sony Corporation Device 81ad > >Flags: bus master, 66MHz, medium devsel, latency 248, IRQ 16 > >Memory at fd000000 (32-bit, non-prefetchable) [size=16M] > >Memory at d0000000 (32-bit, prefetchable) [size=256M] > >[virtual] Expansion ROM at fe9e0000 [disabled] [size=128K] > >Capabilities: <access denied> > >Kernel driver in use: nvidia > > > > > >02:09.0 Multimedia video controller: Internext Compression Inc iTVC16 > >(CX23416) MPEG-2 Encoder (rev 01) > >Subsystem: Sony Corporation Device 816d > >Flags: bus master, medium devsel, latency 64, IRQ 21 > >Memory at f0000000 (32-bit, prefetchable) [size=64M] > >Capabilities: <access denied> > >Kernel driver in use: ivtv > > > >the command dmesg prints the following: > > > >[ 5.023414] ivtv: Start initialization, version 1.4.1 > >[ 5.023576] ivtv0: Initializing card 0 > >[ 5.023583] ivtv0: Unknown card: vendor/device: [4444:0016] > >[ 5.023800] ivtv0: subsystem vendor/device: [104d:816d] > >[ 5.023978] ivtv0: cx23416 based > >[ 5.024127] ivtv0: Defaulting to Hauppauge WinTV PVR-150 card > >[ 5.024286] ivtv0: Please mail the vendor/device and subsystem > >vendor/device IDs and what kind of > >[ 5.024527] ivtv0: card you have to the ivtv-devel mailinglist > >(www.ivtvdriver.org) > >[ 5.024735] ivtv0: Prefix your subject line with [UNKNOWN IVTV CARD]. > >[ 5.025084] ivtv 0000:02:09.0: PCI INT A -> GSI 21 (level, low) -> IRQ > >21 > >[ 5.083469] tveeprom 1-0050: Encountered bad packet header [aa]. > >Corrupt > >or not a Hauppauge eeprom. > >[ 5.083473] ivtv0: Invalid EEPROM > >[ 5.576900] nvidia: module license 'NVIDIA' taints kernel. > >[ 5.576905] Disabling lock debugging due to kernel taint > >[ 5.929392] cx25840 1-0044: cx25 0-21 found @ 0x88 (ivtv i2c driver #0) > >[ 6.140098] nvidia 0000:01:00.0: PCI INT A -> GSI 16 (level, low) -> > >IRQ 16 > >[ 6.140110] vgaarb: device changed decodes: > >PCI:0000:01:00.0,olddecodes=io+mem,decodes=none:owns=io+mem > >[ 6.140392] NVRM: loading NVIDIA UNIX x86 Kernel Module 173.14.27 Tue > >Jul 13 20:39:52 PDT 2010 > >[ 6.855804] cfg80211: Using static regulatory domain info > >[ 6.855810] cfg80211: Regulatory domain: US > >[ 6.855813] (start_freq - end_freq @ bandwidth), (max_antenna_gain, > >max_eirp) > >[ 6.855819] (2402000 KHz - 2472000 KHz @ 40000 KHz), (600 mBi, 2700 > >mBm) > >[ 6.855824] (5170000 KHz - 5190000 KHz @ 40000 KHz), (600 mBi, 2300 > >mBm) > >[ 6.855829] (5190000 KHz - 5210000 KHz @ 40000 KHz), (600 mBi, 2300 > >mBm) > >[ 6.855833] (5210000 KHz - 5230000 KHz @ 40000 KHz), (600 mBi, 2300 > >mBm) > >[ 6.855838] (5230000 KHz - 5330000 KHz @ 40000 KHz), (600 mBi, 2300 > >mBm) > >[ 6.855843] (5735000 KHz - 5835000 KHz @ 40000 KHz), (600 mBi, 3000 > >mBm) > >[ 6.856267] cfg80211: Calling CRDA for country: US > >[ 6.996955] tuner 1-0043: chip found @ 0x86 (ivtv i2c driver #0) > >[ 7.036692] tda9887 1-0043: creating new instance > >[ 7.036698] tda9887 1-0043: tda988[5/6/7] found > >[ 7.057151] All bytes are equal. It is not a TEA5767 > >[ 7.057242] tuner 1-0060: chip found @ 0xc0 (ivtv i2c driver #0) > >[ 7.092353] wm8775 1-001b: chip found @ 0x36 (ivtv i2c driver #0) > >[ 7.095304] wm8775 1-001b: I2C: cannot write 000 to register R23 > >[ 7.098431] wm8775 1-001b: I2C: cannot write 000 to register R7 > >[ 7.101738] wm8775 1-001b: I2C: cannot write 021 to register R11 > >[ 7.104854] wm8775 1-001b: I2C: cannot write 102 to register R12 > >[ 7.107986] wm8775 1-001b: I2C: cannot write 000 to register R13 > >[ 7.111102] wm8775 1-001b: I2C: cannot write 1d4 to register R14 > >[ 7.114211] wm8775 1-001b: I2C: cannot write 1d4 to register R15 > >[ 7.117463] wm8775 1-001b: I2C: cannot write 1bf to register R16 > >[ 7.120602] wm8775 1-001b: I2C: cannot write 185 to register R17 > >[ 7.123701] wm8775 1-001b: I2C: cannot write 0a2 to register R18 > >[ 7.126895] wm8775 1-001b: I2C: cannot write 005 to register R19 > >[ 7.130005] wm8775 1-001b: I2C: cannot write 07a to register R20 > >[ 7.133190] wm8775 1-001b: I2C: cannot write 102 to register R21 > >[ 7.133381] IRQ 21/ivtv0: IRQF_DISABLED is not guaranteed on shared > >IRQs > >[ 7.133984] ivtv0: Registered device video0 for encoder MPG (4096 kB) > >[ 7.134077] ivtv0: Registered device video32 for encoder YUV (2048 kB) > >[ 7.134168] ivtv0: Registered device vbi0 for encoder VBI (1024 kB) > >[ 7.134255] ivtv0: Registered device video24 for encoder PCM (320 kB) > >[ 7.134340] ivtv0: Registered device radio0 for encoder radio > >[ 7.134345] ivtv0: Initialized card: Hauppauge WinTV PVR-150 > >[ 7.134386] tifm_7xx1 0000:02:0b.3: PCI INT A -> GSI 23 (level, low) -> > > > >IRQ 23 > >[ 7.138015] yenta_cardbus 0000:02:0b.0: CardBus bridge found > >[104d:818f] > >[ 7.138037] yenta_cardbus 0000:02:0b.0: Using CSCINT to route CSC > >interrupts to PCI > >[ 7.138043] yenta_cardbus 0000:02:0b.0: Routing CardBus interrupts to > >PCI > >[ 7.138051] yenta_cardbus 0000:02:0b.0: TI: mfunc 0x00021b22, devctl > >0x64 > >[ 7.138612] ivtv: End initialization > > > >I´m not using module options. > > > >the file /var/log/kern.log has the following entries: > > > >Mar 3 03:58:23 localhost kernel: [ 456.129493] tuner 1-0060: tuner type > > > >not set > >Mar 3 03:58:23 localhost kernel: [ 456.132442] wm8775 1-001b: I2C: > >cannot write 0c0 to register R21 > >Mar 3 03:58:23 localhost kernel: [ 456.135412] wm8775 1-001b: I2C: > >cannot write 1d4 to register R14 > >Mar 3 03:58:23 localhost kernel: [ 456.138366] wm8775 1-001b: I2C: > >cannot write 1d4 to register R15 > >Mar 3 03:58:23 localhost kernel: [ 456.141322] wm8775 1-001b: I2C: > >cannot write 102 to register R21 > > > >Now my question: > > > >Can anybody help me to get this tv-card running? > > > >Thank you for your help. > > > >Alex > > > >_______________________________________________ > >ivtv-users mailing list > >[email protected] > >http://ivtvdriver.org/mailman/listinfo/ivtv-users > > Alex, > > Your card is not supported under linux. There is a custom Sony chip on the > card for which no information is available: > > http://ivtvdriver.org/pipermail/ivtv-devel/2008-October/005801.html > > Regards, > Andy > > _______________________________________________ > ivtv-users mailing list > [email protected] > http://ivtvdriver.org/mailman/listinfo/ivtv-users >
_______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
