Hi guys

   I am finally getting into creating the K107 library and have run into 
a lack of knowledge of JAL.

In this case I am trying to get a procedure to initialize the K107 
backpack for one of 6 geometries.  My inexperience in jal is showing as 
I can't get this compile.  Suggestions for a better method would be 
appreciated.

procedure k107_init(byte in  geo) is
     case geo of
         216:    const byte cmd[] = "?G216"
         220:    const byte cmd[] = "?G220"
         224:    const byte cmd[] = "?G224"
         240:    const byte cmd[] = "?G240"
         416:    const byte cmd[] = "?G416"
         420:    const byte cmd[] = "?G420"
     end case
     for 5 using i loop
         serial_sw_write(cmd[i])
     end loop
--  delay required when writing to K107 EEPROM
     delay_100ms(2)
end procedure

The error is 'cmd' previously defined.

I have tries other code to get this done but want to cut the code down 
as much as possible.  I still want to use this in a 12f675, while using 
the library.

I am using the latest jallib-pack.  You guys have been busy!  I haven't 
caught up with all the mail list since my systems were down, but I'm 
getting there.

Regards

Wayne

--~--~---------~--~----~------------~-------~--~----~
You received this message because you are subscribed to the Google Groups 
"jallib" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to 
[email protected]
For more options, visit this group at 
http://groups.google.com/group/jallib?hl=en
-~----------~----~----~----~------~----~------~--~---

Reply via email to