Hi, First time I've tried using internal oscillator.... no success. I've tried 2 different setups, posted below. Both compiled & downloaded with no errors. No Blinking on A0. What am I doing wrong? Thanks! - John
Version 1: include 18f43k20 -- target PICmicro -- pragma target clock 8_000_000 -- oscillator frequency -- configuration memory settings (fuses) pragma target OSC INTOSC_NOCLKOUT -- INTOSC pragma target WDT disabled -- no watchdog pragma target LVP disabled -- no Low Voltage Programming pragma target MCLR external -- reset externally OSCCON = 0x7f enable_digital_io() -- disable analog I/O (if any) -- enable_digital_io() -- make all pins digital I/O -- -- Specify the pin to which the LED (with serial resistor!) is connected: alias led is pin_A0 pin_A0_direction = output -- forever loop led = on _usec_delay(250_000) led = off _usec_delay(250_000) end loop -- Version 2: include 18f43k20 -- target PICmicro -- pragma target clock 8_000 -- oscillator frequency -- configuration memory settings (fuses) pragma target OSC INTOSC_NOCLKOUT pragma target WDT disabled -- no watchdog pragma target DEBUG disabled -- no debugging pragma target LVP disabled -- no Low Voltage Programming pragma target MCLR external -- reset externally enable_digital_io() -- make all pins digital I/O -- -- Specify the pin to which the LED (with serial resistor!) is connected: alias led is pin_A0 pin_A0_direction = output -- forever loop led = on _usec_delay(250_000) led = off _usec_delay(250_000) end loop -- -- You received this message because you are subscribed to the Google Groups "jallib" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/jallib?hl=en.
