This may be possible, but after altering the baud rate, you will have to call the init procedure again, as the baudrate constant is only used to set the baud rate registers once. Greets, Kiste
> > >Hi Sunish, > > >Did not dig into the code, but you could declare baudrate as a variable, not a >constant. I had the same issue with ADC libraries. Instead of using constant, >I used variables to modify at runtime ADC behavior. I had to modify library >itself in the end... I don't think it's not doable, but it may require to >change the lib. > > >Let us know > > >Cheers >Seb > > > >On 24 February 2013 10:51, Sunish Issac <[email protected]> wrote: > >I have a requirement where the baudrate of the sender can be either 2400,4800 >and 9600. >>The sending device is a weighing machine and it sends data continuosly, so >>the plan was to try verify the characters and then if its not valid try the >>next baud. >> >>Since the library expects a constant for baudrate, its directly not possible >>to try other baudrates, Any suggestions ? >> >>Sunish >>-- >>You received this message because you are subscribed to the Google Groups >>"jallib" group. >>To unsubscribe from this group and stop receiving emails from it, send an >>email to [email protected]. >>To post to this group, send email to [email protected]. >>Visit this group at http://groups.google.com/group/jallib?hl=en. >>For more options, visit https://groups.google.com/groups/opt_out. >> >> >> > > > >-- >Sébastien Lelong > > -- >You received this message because you are subscribed to the Google Groups >"jallib" group. >To unsubscribe from this group and stop receiving emails from it, send an >email to [email protected]. >To post to this group, send email to [email protected]. >Visit this group at http://groups.google.com/group/jallib?hl=en. >For more options, visit https://groups.google.com/groups/opt_out. > > > > > -- You received this message because you are subscribed to the Google Groups "jallib" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/jallib?hl=en. For more options, visit https://groups.google.com/groups/opt_out.
