Thanks, I've now installed that one (after having deleted the previous folder) and I get the same .hex file as Rob. Still no blinking led though. which makes me believe it might be hardware related after all. More specific the MCLR circuit. This pin is tied to Vcc via an 33k resistor according to Wouters schematic. I changed it to an 10k resistor and a switch to pull it directly to ground for the reset. This works fine for Wouters code but not for the one I compiled from the example. After I programmed the new code and it wasn't working I changed some of the layout of the breadboard and added a few more decoupling capacitors. Next time I turned on he power supply it did blink 2/s but when I tried to change that to once every 5 seconds again nothing. I'll triple-check my hardware again tomorrow, might be something as simple as a bad connection in the breadboard.
-- You received this message because you are subscribed to the Google Groups "jallib" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/jallib. For more options, visit https://groups.google.com/d/optout.
