Hello,
This means often that in the lines before the line the error occurred a type error has
been made. Check this out.
Greetings Marcel
[EMAIL PROTECTED]@[EMAIL PROTECTED] on 05/18/2000 01:42:03 AM
Please respond to [EMAIL PROTECTED]@SMTP
Sent by: [EMAIL PROTECTED]
To: [EMAIL PROTECTED]@SMTP
cc:
Subject: [JAVA3D] javac error message
Classification: Restricted
Hi:
I'm using javac 1.2 and am getting the following error message for my
Java 3D program:
jDend.java:78: Type expected.
length_shaft_11.setCoordinates ( 0, length_shaft_11_points );
^
Why is it giving me a Type error at a constant of 0 (zero)? All
help is greatly appreciated!
Sincerely,
Mona
==================================================================
Mona Wong
National Center for Microscopy and Imaging Research
University of California, San Diego
http://www-ncmir.ucsd.edu/
"The truth shall set you free, but first it will piss you off"
A Landmark instructor
==================================================================
===========================================================================
To unsubscribe, send email to [EMAIL PROTECTED] and include in the body
of the message "signoff JAVA3D-INTEREST". For general help, send email to
[EMAIL PROTECTED] and include in the body of the message "help".
===========================================================================
To unsubscribe, send email to [EMAIL PROTECTED] and include in the body
of the message "signoff JAVA3D-INTEREST". For general help, send email to
[EMAIL PROTECTED] and include in the body of the message "help".
