All: First off - newbie alert. I am just beginning to work with USB devices and quite frankly haven't really grasped them yet. I would RTFM if only I knew where it was.
I am looking for some instructions/pseudocode on talking to an HID device. The device is a PowerLincv2 controller from Smarthome. It functions as a controller for controlling X10 and insteon devices. Based on the dev docs one sends an 8 byte HID packet (0x02, 0x02 0x48,0x00,0x00,0x00,0x00,0x00) where the first byte is Count and the remaining 7 are data. The device then responds with 5 8 byte packets again with the first byte for Count and the next 7 for data. So far I've been able to find the device on the bus and query it. I can access the configurations, interface and endpoints. What I can't figure out is the general process/flow for sending data to the device and then reading the response. I've looked over the examples, but only the Mouse driver comes close to what I am trying to do, and I don't fully understand it. Could someone provide some basic info on how to accomplish this. Mostly what I need is pseudocode ro a set of general instructions - do this, then do this, then do this. Thanks! -steve ------------------------------------------------------- This SF.Net email is sponsored by the JBoss Inc. Get Certified Today * Register for a JBoss Training Course Free Certification Exam for All Training Attendees Through End of 2005 Visit http://www.jboss.com/services/certification for more information _______________________________________________ javax-usb-devel mailing list javax-usb-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/javax-usb-devel
