That did it. Once I downgraded to the 1.4-b4 release, the tutorial started to behave much better. I don't understand it but I'd assumed the 1.4 release would behave as good or better than the beta.
Thanks Youssef, Mazin --- Youssef Mohammed <[EMAIL PROTECTED]> wrote: > Well Mazin basha , > > it says in the top page of the tutorial that > "Note: This tutorial applies to the Jetspeed 1.4b4 > release" > > Soo there are not guarantee it will work with 1.4 > as i think > > > -----Original Message----- > > From: Mazin Mustafa > [mailto:[EMAIL PROTECTED] > > Sent: Tuesday, December 30, 2003 10:41 PM > > To: [EMAIL PROTECTED] > > Subject: Tutorial step 5 problem > > > > > > Hello, > > I managed to setup Jetspeed 1.4 with Tomcat 4.1.29 > on Red Hat > > 9. The tutorial was working fine until I reached > step 5. As I > > bring up the customizer, I do get the same screen > for the > > portlets. Instead, I see a list of 1,2,3,4. When I > click on > > any of them, I get a Tomcat error message stating: > > HTTP Status 404 - /jportal/$jslink.getAction( > > The requested action is not available. > > I tried to debug with my very limited knowledge > and noticed > > that the same action works on tutorial 1. I tried > the > > customizer with tutorial 2 and got the same error. > > > > The archives didn't seem anything resembling this > issue at > > least not that I can find. > > > > Mazin > > > > ATTACHMENT part 2 application/x-pkcs7-signature name=smime.p7s --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
