Hi Mario, no it's not restricted to windows 10, it's meant to work in Microsoft programs such as wordpad and word,
David. On Wed, Mar 2, 2016 at 10:01 am, Mario <[email protected]> wrote: David, then the alt+x is a windows 10 feature? On 3/2/2016 12:02 PM, David Bailes wrote: Hi Mario, I'd forgotten about pressing numpad 5 three times, that's much easier. (alt+x is a windows keystroke, rather than a Jaws keystroke) David. On Wed, Mar 2, 2016 at 06:36 am, Mario <[email protected]> wrote: David, the alt+x must be a feature in JAWS 17? because I'm using J16 and alt+x gives me a ding sound. the way I know is to navigate to the character and press the numpad 5 three times quickly. this should give the ASCII value or the Unicode if it is a symbol. then just press the numpad 5 key once to toggle off the mode, because if you keep navigating character by character, you'll get the ASCII/unicode of the next/previous character/symbol. I'm not sure what the laptop equivalent would be if you don't have a numpad. On 3/2/2016 5:18 AM, David Bailes wrote: Hi Tim, I think the following should work in word - I've tested it in wordpad. To find out the hex value of a character, move to the character after that character and press alt+x. The character is replaced by the hex value, and this value is selected. You can go back to the original character by pressing alt+x again. Notes: 1. normally using alt+x, is used for inserting Unicode characters using their hex value, rather than the other way round. 2. This won't word for the characters a,b,c,d,e, and f, because they're used in hex. David. On Wed, Mar 2, 2016 at 12:11 am, Tim Ford <[email protected]> wrote: Hi All, I have a document that has, scattered throughout, a lot of mysterious consecutive characters that I want to delete globally using Word. However, JAWS describes them only as “blank” (without the “). I vaguely recall back in my DOS days about being able to enter the ASCII number for a character to produce it. Is there a keystroke in JAWS whereby I can put my cursor on the mysterious character, and find out what it is in terms of an ASCII number, then enter that into the global search and replace? Tim Ford
